Related papers: Near-field scanning microwave microscope for inter…
We measured ferromagnetic resonance of a single submicron ferromagnetic strip, embedded in an on-chip microwave transmission line device. The method used is based on detection of the oscillating magnetic flux due to the magnetization…
Electrical contact resistance or capacitance as measured between a lubricated contact has been used in tribometers, partially reflecting the lubrication condition. In contrast, the electrical impedance provides rich information of magnitude…
We present a study of interlayer coupling and proximity effects in a La$_{0.66}$Ca$_{0.33}$MnO$_3$(10 nm)/YBa$_2$Cu$_3$O$_7$(10 nm) superlattice. Using element-sensitive x-ray probes, the magnetic state of Mn can be probed without seeing…
Superconducting quantum interference devices (SQUIDs) are used for applications ranging from sensitive magnetometers to low-temperature electronics and quantum computation. We introduce a planar nano SQUID that was made with a single…
We demonstrate a suspended thin-film aluminum nitride (AlN) microbolometer for narrowband very long-wave infrared detection. The device uses a 100-nm-thick AlN membrane suspended above a Pt back reflector by a 1-um air gap. Resonant…
III-V semiconductor mid-infrared photodetectors based on intersubband transitions hold a great potential for ultra-high-speed operation up to several hundreds of GHz. In this work we exploit a ~350nm-thick GaAs/Al0.2Ga0.8As…
The design and performance of a sensitive and reliable cross-correlation spectrum analyzer for studying low frequency transport noise is described in detail. The design makes use of common PC-based data acquisition hardware and…
Microwaves generated by optical techniques have demonstrated unprecedentedly low noise and hold significance in various applications such as communication, radar, instrumentation, and metrology. To date, the purest microwave signals are…
Near-field imaging experiments exist both in optics and microwaves with often different methods and theoretical supports. For millimeter waves or THz waves, techniques from both fields can be merged to identify materials at the micron scale…
Scanning Probe Microscopy is used to study and quantify the nanoscale electric phenomena in the two classes of oxide systems, namely transport at electroactive grain boundaries and surface behavior of ferroelectric materials. Scanning…
We report local conductivity imaging of edge states in monolayer graphene by millikelvin microwave impedance microscopy (MIM). At the charge-neutrality point, as the magnetic field increases, the local conductivity at the edge drops to zero…
This work focuses on the development and demonstration of tunable superconducting on-chip resonator, leveraging the intrinsic current-dependent non-linear kinetic inductance of superconducting aluminium, and investigating the effect of…
We have designed and tested a robust 20 $\times$ 20 cm$^2$ thin metal film internal anode capacitively coupled to an external array of signal pads or micro-strips for use in fast microchannel plate photodetectors. The internal anode, in…
This paper presents the design and performance analysis of a 1x6 linear microstrip patch antenna array tailored for automotive radar and 5G millimetre-wave (mm-wave) applications. The proposed antenna array comprises six rectangular…
We design and test a low-loss interface between superconducting 3-dimensional microwave cavities and 2-dimensional circuits, where the coupling rate is highly tunable. This interface seamlessly integrates a loop antenna and a Josephson…
Modern interfacial science is increasingly multi-disciplinary. Unique insight into interfacial interactions requires new multimodal techniques for interrogating surfaces with simultaneous complementary physical and chemical measurements. We…
Various bandstructure engineering methods have been studied to improve the performance of graphitic transparent conductors; however none demonstrated an increase of optical transmittance in the visible range. Here we measure in situ optical…
Infrared imaging is a crucial technique in a multitude of applications, including night vision, autonomous vehicles navigation, optical tomography, and food quality control. Conventional infrared imaging technologies, however, require the…
Nanopores made with low dimensional semiconducting materials, such as carbon nanotubes and graphene slit pores, are used in supercapacitors. In theories and simulations of their operation, it is often assumed that such pores screen ion-ion…
Superconducting Quantum Interference Devices (SQUIDs) can have excellent spin sensitivity depending on their magnetic flux noise, pick-up loop diameter, and distance from the sample. We report a family of scanning SQUID susceptometers with…