Related papers: Thermal-noise limited laser stabilization to a cry…
The thermal fluctuation of mirror surfaces is the fundamental limitation for interferometric gravitational wave (GW) detectors. Here, we experimentally demonstrate for the first time a reduction in a mirror's thermal fluctuation in a GW…
We report on the demonstration and characterization of a silicon optical resonator for laser frequency stabilization, operating in the deep cryogenic regime at temperatures as low as 1.5 K. Robust operation was achieved, with absolute…
Three-mode parametric instability is a threat to attaining design power levels in Advanced gravitational wave detectors. The first observation of three-mode parametric instability in a long optical cavity revealed that instabilities could…
Thermal noise in optical cavities imposes a severe limitation in the stability of the most advanced frequency standards at a level of a few 10^(-16) (s/t)^(1/2) for long averaging times t. In this paper we describe two schemes for reducing…
We report a simple technique for stabilization of a laser frequency at the wings of an atomic resonance. The reference signal used for stabilization issues from interference effects obtained in a low-quality cavity filled with a resonant…
Liquid droplet whispering-gallery-mode microresonators open a new research frontier for optomechanics and photonic devices. At visible wavelengths, where most liquids are transparent, a major contribution to a droplet optical quality factor…
Controlled tuning of the whispering gallery modes of GaN/InGaN {\mu}-disk cavities is demonstrated. The whispering gallery mode (WGM) tuning is achieved at room temperature by immersing the {\mu}-disks in water and irradiating with…
Thermal noise of the dielectric mirror coatings can limit laser-optical high-precision measurements. Coatings made of amorphous silicon and silicon nitride could provide a remedy for both gravitational-wave detectors and optical clocks.…
We characterize the frequency-sensitivity of a cavity-stabilized laser to inertial forces and temperature fluctuations, and perform real-time feed-forward to correct for these sources of noise. We measure the sensitivity of the cavity to…
We report on a laser locked to a silicon cavity operating continuously at 4 K with $1 \times 10^{-16}$ instability and a median linewidth of 17 mHz at 1542 nm. This is a ten-fold improvement in short-term instability, and a $10^4$…
A thermal atomic ensemble-based laser source with superior frequency stability is proposed that relies on the accumulated contributions from an abundance of nonzero-transverse-velocity atomic ensembles. Compared with the traditional case in…
We present an ultrahigh-$Q$, solid-silica microrod resonator operated under ambient conditions that supports laser-fractional-frequency stabilization to the thermal-noise limit of $3 \times 10^{-13}$ and a linewidth of 62 Hz. We…
We demonstrate thermometry with a resolution of 80 $\mathrm{nK} / \sqrt{\mathrm{Hz}}$ using an isotropic crystalline whispering-gallery mode resonator based on a dichroic dual-mode technique. We simultaneously excite two modes that have a…
Optical resonators are used for the realisation of ultra-stable frequency lasers. The use of high reflectivity multi-band coatings allows the frequency locking of several lasers of different wavelengths to a single cavity. While the noise…
We demonstrate a self-homodyne detection method to stabilize a continuous-wave 1550-nm laser to a 1-km optical fiber delay line, achieving a frequency instability of 6.3x10<sup>-15</sup> at a 16-ms averaging time. This result, limited by…
We report on the development of a frequency modulatable 795 nm semiconductor laser based on self-injection locking to a high quality factor whispering gallery mode microresonator. The laser is characterized with residual amplitude…
A low maintenance long-term operational cryogenic sapphire oscillator has been implemented at 11.2 GHz using an ultra-low-vibration cryostat and pulse-tube cryocooler. It is currently the world's most stable microwave oscillator employing a…
We present the design and performance characterization of an external cavity diode-laser system optimized for high stability, low passive spectral linewidth, low cost, and ease of in-house assembly. The main cavity body is machined from a…
Optical frequency stabilization is a critical component for precision scientific systems including quantum sensing, precision metrology, and atomic timekeeping. Ultra-high quality factor photonic integrated optical resonators are a prime…
An extended cavity diode laser operating in the Littrow configuration emitting near 657 nm is stabilized via its injection current to a reference cavity with a finesse of more than 10^5 and a corresponding resonance linewidth of 14 kHz. The…