Related papers: Magnetron Sputtered NbN Films with Nb Interlayer

Al2O3 thin films have been deposited at substrate temperatures between 500{\deg}C to 600{\deg}C by reactive magnetron sputtering using an additional arbitrary substrate bias to tailor the energy distribution of the incident ions. The films…

In this work, we studied cobalt nitride (Co-N) thin films deposited using a dc magnetron sputtering method at a substrate temperature (\Ts) of 523\,K. We find that independent of the reactive gas flow (\pn) used during sputtering, the…

We report effect of Gd inclusion in the NbN superconductor thin films. The films are deposited on single crystalline Silicon (100) by DC reactive sputtering technique i.e., deposition of Nb and Gd in presence of reactive N2 gas. The…

Nanoscale metallic multilayer (NMM) films are systems offering insight into the role of interfaces in metal plasticity, deformation, and strengthening mechanisms. Magnetron sputtering was used to fabricate the Ta-Cu NMM films with a…

Micron-thick boron films have been deposited by Pulsed Laser Deposition in vacuum on several substrates at room temperature. The use of high energy pulses (>700 mJ) results in the deposition of smooth coatings with low oxygen uptake even at…

This paper presents the development of scientific instrumentation for the fabrication of ferromagnetic thin films, by sputtering technique, for the use of 2-inch-diameter targets. Thin films were deposited using Permalloy alloy (Ni80Fe20)…

We fabricated superconducting MgB2 thin films on (001) MgO substrates. The samples were prepared by magnetron rf and dc co-sputtering on heated substrates. They were annealed ex-situ for one hour at temperatures between 450{\deg}C and…

Ta (100 nm) / NdFeB (5 $\mu$m) / Ta (100 nm) films have been deposited onto Si substrates using triode sputtering (deposition rate ~ 18 $\mu$m/h). A 2-step procedure was used : deposition at temperatures up to 400 C followed by ex-situ…

Ga2O3 thin films were deposited by reactive magnetron sputtering from a liquid gallium target. The influence of deposition temperature, substrate type, and discharge parameters on the structural and electrical properties was systematically…

We report on an XPS study of AlN thin films grown on Si(100) substrates by ion beam sputter deposition (IBSD) in reactive assistance of N+/N2+ ions to unravel the compositional variation of their surface when deposited at different…

We report on combined resistance and magnetic measurements in a hybrid structure (HS) of randomly distributed anisotropic CoPt magnetic nanoparticles (MN) embedded in a 160 nm Nb thick film. Our resistance measurements exhibited a sharp…

Copper ferrite thin films were deposited on amorphous quartz substrates. The as deposited films were annealed in air and either quenched or slow cooled. Magnetization studies were carried out on the as deposited as well as annealed films…

We investigated the suitability of AlN as a buffer layer for NbN superconducting nanowire single-photon detectors (SNSPDs) on GaAs. The NbN films with a thickness of 3.3 nm to 20 nm deposited onto GaAs substrates with AlN buffer layer,…

Epitaxial copper thin films were deposited by magnetron sputtering. The adatoms during deposition are influenced by deposition parameters which cause variations in thin film properties. XRD and FESEM studies were done to get an insight into…

The mechanical vulnerability of the Nb3Sn-coated cavities is identified as one of the significant technical hurdles toward deploying them in practical accelerator applications in the not-so-distant future. It is crucial to characterize the…

We introduce a simple method of an MgB2 film preparation using sequential electron-beam evaporation of B-Mg two-layer (followed by in-situ annealing) on the NbN buffered Si(100) substrate. The Transmission Electron Microscopy analyses…

We report the reduction in residual stress of AlN thin films and also the crystal structure, surface morphology and nanomechanical properties of magnetron sputtered as a function of substrate temperature (Ts, 35 - 600 ?C). The residual…

NbO2 is a potential material for nanometric memristor devices, both in the amorphous and the crystalline form. We fabricated NbO2 thin films using RF-magnetron sputtering from a stoichiometric target. The as-deposited films were amorphous…

Amorphous boron carbide (B4C) thin films are by far the most popular form for the neutron converting layers in the 10B-based neutron detectors, which are a rising trend in detector technologies in response to the increasing scarcity and…

We report a milestone in achieving large-scale, ultrathin (~5 nm) superconducting NbN thin films on 300 mm Si wafers using a high-volume manufacturing (HVM) industrial physical vapor deposition (PVD) system. The NbN thin films possess…