Related papers: High On/Off Ratio Graphene Nanoconstriction Field …
We perform ab initio calculations of charged graphene and single-wall carbon nanotubes (CNTs). A wealth of electromechanical behaviors is obtained: (1) Both nanotubes and graphene expand upon electron injection. (2) Upon hole injection,…
A blueprint for producing scalable digital graphene electronics has remained elusive. Current methods to produce semiconducting-metallic graphene networks all suffer from either stringent lithographic demands that prevent reproducibility,…
Carbon Nanotube Field Effect Transistor (CNFET) is a promising new technology that overcomes several limitations of traditional silicon integrated circuit technology. In recent years, the potential of CNFET for analog circuit applications…
Atomically precise graphene nanoribbons (GNRs) are predicted to exhibit exceptional edge-related properties, such as localized edge states, spin polarization, and half-metallicity. However, the absence of low-resistance nano-scale…
The influence of defects on electron transport in single-wall carbon nanotube field effect transistors (CNFETs) is probed by combined scanning gate microscopy (SGM) and scanning impedance microscopy (SIM). SGM reveals a localized field…
While decreasing the oxide thickness in carbon nanotube field-effect transistors (CNFETs) improves the turn-on behavior, we demonstrate that this also requires scaling the range of the drain voltage. This scaling is needed to avoid an…
We measure top-gated graphene field effect transistors (GFETs) with nanosecond-range pulsed gate and drain voltages. Due to high-k dielectric or graphene imperfections, the drain current decreases ~10% over time scales of ~10 us, consistent…
Phase change memory (PCM) devices are known to reduce in power consumption as the bit volume and contact area of their electrodes are scaled down. Here, we demonstrate two types of low-power PCM devices with lateral graphene ribbon…
The cold source field-effect transistor (CSFET) is promising for reducing power dissipation in integrated circuits by engineering the density of states at the injecting source. Existing CSFET designs utilizing Dirac-source metals or…
In this study, a SPICE model for negative capacitance vertical nanowire field-effect-transistor (NC VNW-FET) based on BSIM-CMG model and Landau-Khalatnikov (LK) equation was presented. Suffering from the limitation of short gate length…
We investigate electronic transport in lithographically patterned graphene ribbon structures where the lateral confinement of charge carriers creates an energy gap near the charge neutrality point. Individual graphene layers are contacted…
Graphene nanoribbons have attracted attention for their novel electronic and spin transport properties1-6, and because nanoribbons less than 10 nm wide have a band gap that can be used to make field effect transistors. However, producing…
Recently developed processes have enabled bottom-up chemical synthesis of graphene nanoribbons (GNRs) with precise atomic structure. These GNRs are ideal candidates for electronic devices because of their uniformity, extremely narrow width…
We showed in past work that nanopatterned monolayer graphene (NPG) enables spectrally selective thermal emission in the mid-infrared (mid-IR) from 3 to 12 $\mu$m. In that case the spectral selection is realized by means of the localized…
This letter reports the impact of surface morphology on the carrier transport and RF performance of graphene FETs formed on epitaxial graphene films synthesized on SiC substrates. Such graphene exhibits long terrace structures with widths…
We develop a simple and scalable graphene patterning method using electron-beam or ultraviolet lithography followed by a lift-off process. This method, with the merits of: high pattern resolution and high alignment accuracy, free from…
Conductance fluctuation is usually unavoidable in graphene nanoribbons (GNR) due to the presence of disorder along its edges. By measuring the low-frequency noise in GNR devices, we find that the conductance fluctuation is strongly…
We study the channel width scaling of back-gated MoS2 metal-oxide-semiconductor field-effect transistors (MOSFETs) from 2 {\mu}m down to 60 nm. We reveal that the channel conductance scales linearly with channel width, indicating no evident…
Graphene is an attractive electrode material to contact nanostructures down to the molecular scale since it can be gated electrostatically. Gating can be used to control the doping and the energy level alignment in the nanojunction, thereby…
The use of carbon nanotube (CNT) field-effect transistors (FETs) in microwave circuit design requires an appropriate, immediate and efficient description of their performance. This work describes a technique to extract the parameters of an…