Related papers: Gaussian approximation and single-spin measurement…
The MRFM device is a powerful setup for manipulating single electron spin in resonance in a magnetic field. However, the real time observation of a resonating spin is still an issue because of the very low SNR of the output signal. This…
We study theoretically the measurement of a mechanical oscillator using a single two level system as a detector. In a recent experiment, we used a single electronic spin associated with a nitrogen vacancy center in diamond to probe the…
Individual electron spins have been observed using magnetic resonance in combination with a number of distinct detection approaches. The coordinates of an individual electron spin can then in principle be determined by introducing a 10 to…
We implement magnetic resonance force microscopy (MRFM) in an experimental geometry, where the long axis of the cantilever is normal to both the external magnetic field and the RF microwire source. Measurements are made of the statistical…
Using a magnetic resonance force microscope (MRFM), the power emitted by a spin transfer nano-oscillator consisting of a normally magnetized Py$|$Cu$|$Py circular nanopillar is measured both in the autonomous and forced regimes. From the…
Magnetic Resonance Force Microscopy (MRFM) describes a range of approaches to detect nuclear spins with mechanical sensors. MRFM has the potential to enable magnetic resonance imaging (MRI) with near-atomic spatial resolution, opening up…
We review recent efforts to detect small numbers of nuclear spins using magnetic resonance force microscopy. Magnetic resonance force microscopy (MRFM) is a scanning probe technique that relies on the mechanical measurement of the weak…
We report on the design, fabrication, and implementation of ultrasensitive micromechanical oscillators. Our ultrathin single-crystal silicon cantilevers with integrated magnetic structures are the first of their kind: They are fabricated…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
We present the design and implementation of a scanning probe microscope, which combines electrically detected magnetic resonance (EDMR) and (photo-)conductive atomic force microscopy ((p)cAFM). The integration of a 3-loop 2-gap X-band…
We measure the dissipation and frequency shift of a magnetically coupled cantilever in the vicinity of a silicon chip, down to $25$ mK. The dissipation and frequency shift originates from the interaction with the unpaired electrons,…
Magnetic Resonance Force Microscopy (MRFM) enables three-dimensional imaging of nuclear spin densities in nanoscale objects. Based on numerical simulations, we evaluate the performance of strained SiN resonators as force sensors and show…
Magnetic Resonance Force Microscopy can enable nanoscale imaging of spin lifetime. We report temperature dependent measurements of the spin correlation time $\tau_m$ of the statistical fluctuations of the spin polarization---the spin…
In this work is presented a microbalance for single microparticle sensing based on resonating AFM cantilever. The variation of the resonator eigenfrequency is related to the particle mass positioned at the free apex of the cantilever. An…
We analyze the back-action influence of nuclear spins on the motion of the cantilever of a magnetic force resonance microscope. We calculate the contribution of nuclear spins to the damping and frequency shift of the cantilever. We show…
A comprehensive study of a force detected single-spin magnetic resonance measurement concept with atomic spatial resolution is presented. The method is based upon electrostatic force detection of spin-selection rule controlled…
Measuring spins is the corner stone of a variety of analytical techniques including modern magnetic resonance imaging (MRI). The full potential of spin imaging and sensing across length scales is hindered by the achievable signal-to-noise…
A mechanical electroscope based on a change in the resonant frequency of a cantilever one micron in size in the presence of charge has recently been fabricated. We derive the decoherence rate of a charge superposition during measurement…
The extensive research and development of micromechanical resonators is trying to allow the use of these devices for highly sensitive applications. Microcantilevers are some of the simplest MEMS structure and had been proved to be a good…
Magnetic resonance force microscopy (MRFM) is a scanning probe technique capable of detecting MRI signals from nanoscale sample volumes, providing a paradigm-changing potential for structural biology and medical research. Thus far, however,…