Related papers: A High Precision Fabry-Perot Cavity Polarimeter at…
A new Compton longitudinal polarimeter currently under construction for HERA is presented. The key component of the polarimeter is a Fabry-Perot cavity located around the electron beam pipe. With such an optical cavity, a continuous laser…
A precise and fast Fabry-Perot cavity polarimeter, installed in the HERA tunnel in the summer of 2003, was used to measure the longitudinal polarisation of the lepton beam. A complete theoretical model has been developed in order to control…
The design, construction and operation of a Compton back-scattering laser polarimeter at the HERA storage ring at DESY are described. The device measures the longitudinal polarization of the electron beam between the spin rotators at the…
A high-finesse Fabry-Perot cavity with a frequency-doubled continuous wave green laser (532~nm) has been built and installed in Hall A of Jefferson Lab for high precision Compton polarimetry. The infrared (1064~nm) beam from a…
A major advance in accurate electron beam polarization measurement has been achieved at Jlab Hall A with a Compton polarimeter based on a Fabry-Perot cavity photon beam amplifier. At an electron energy of 4.6 GeV and a beam current of 40…
A Compton polarimeter has been installed in Hall A at Jefferson Laboratory. This letter reports on the first electron beam polarization measurements performed during the HAPPEX experiment at an electron energy of 3.3 GeV and an average…
A measurement of the longitudinal polarization of the electron beam at HERA utilizing coherent interactions of high energy photons in crystals is proposed. Modification of existing facilities would allow an independent polarization…
A novel polarisation modulation scheme for polarimeters based on Fabry-Perot cavities is presented. The application to the proposed HERA-X experiment aiming to measuring the magnetic birefringence of vacuum with the HERA superconducting…
We introduce a laser heterodyne polarimeter designed for the precision measurement of sub $\mu\mathrm{rad}$ differential phase shifts due to birefringence. The polarimeter will be used in an initial testbed for a potential future vacuum…
We give the results of an analysis of some 18 rise-time calibrations which are based on data collected in 1996/97. Such measurements are used to determine the absolute polarization scale of the transverse electron beam polarimeter (TPOL) at…
For the 1994/95 run of the SLD experiment at SLAC, a Compton polarimeter measured the luminosity-weighted electron beam polarization to be (77.2 +- 0.5)%. This excellent accuracy is achieved by measuring the rate asymmetry of…
Longitudinal polarisation of the lepton beam is a key ingredient to the success of the world's unique e\pmp ring collider HERA. This article aims at providing a brief introduction to the physics motivation for deep-inelastic scattering of…
High-finesse microcavities offer a platform for compact, high-precision sensing by employing high-reflectivity, low-loss mirrors to create effective optical path lengths that are orders of magnitude larger than the device geometry. Here, we…
Optical Fabry-Perot cavities always show a non-degeneracy of two orthogonal polarisation states. This is due to the unavoidable birefringence of dielectric mirrors whose effects are extremely important in Fabry-Perot based high-accuracy…
A wide range of nucleon and nuclear structure experiments in Jefferson Lab's Hall A require precise, continuous measurements of the polarization of the electron beam. In our Compton polarimeter, electrons are scattered off photons in a…
Transmission electron microscopy (TEM) of vitrified biological macromolecules (cryo-EM) is limited by the weak phase contrast signal that is available from such samples. Using a phase plate would thus substantially improve the…
A class of multiwavelength Fabry-Perot lasers is introduced where the spectrum is tailored through a non-periodic patterning of the cavity effective index. The cavity geometry is obtained using an inverse scattering approach and can be…
We describe the design and operation of a high-stability Fabry-Perot cavity, for laser stabilization in cavity quantum-electrodynamics experiments. Our design is based on an inexpensive and readily available uniaxial carbon-fiber reinforced…
We have built a polarimeter in order to measure the electron beam polarization in hall C at JLAB. Using a superconducting solenoid to drive the pure-iron target foil into saturation, and a symmetrical setup to detect the Moller electrons in…
We report on the highest precision yet achieved in the measurement of the polarization of a low energy, $\mathcal{O}$(1 GeV), electron beam, accomplished using a new polarimeter based on electron-photon scattering, in Hall~C at Jefferson…