Related papers: Experimental Demonstration of Time-Delay Interfero…
LISA is an array of three spacecraft in an approximately equilateral triangle configuration which will be used as a low-frequency gravitational wave detector. We present here new generalizations of the Michelson- and Sagnac-type time-delay…
The displacement-noise-free interferometer (DFI) is designed to eliminate all displacement-induced noise while retaining sensitivity to gravitational wave (GW) signals. Ground-based DFIs suffer from physical arm-length limitations,…
Space gravitational wave detectors employing laser interferometry between free-flying spacecraft differ in many ways from their laboratory counterparts. Among these differences is the fact that, in space, the end-masses will be moving…
Precision phase readout of optical beat note signals is one of the core techniques required for intersatellite laser interferometry. Future space based gravitational wave detectors like eLISA require such a readout over a wide range of MHz…
The optical truss interferometer (OTI) is a contingent subsystem proposed for the LISA telescopes to aid in the verification of a $1 \frac{\mathrm{pm}}{\sqrt{\mathrm{Hz}}}$ optical path length stability. Each telescope would be equipped…
Time-delay interferometry (TDI) is a crucial technology for space-based gravitational wave detectors. Previous studies have identified the optimal TDI configuration for the first-generation. In this research, we used an Algebraic approach…
Objects sensed by laser interferometers are usually not stable in position or orientation. This angular instability can lead to a coupling of angular tilt to apparent longitudinal displacement -- tilt-to-length coupling (TTL). In LISA this…
Low-noise temperature measurements at frequencies in the milli-Hertz range are needed in the LISA and LISA PathFinder (LPF). The required temperature stability for LISA is around 10 uK/sqrt(Hz) at frequencies down to 0.1 mHz. In this paper…
Proper tuning of the orbital characteristics of the three spacecrafts that constitute the usual triangular configuration of the space-borne gravitational-wave detector LISA, could minimize the breathing mode of its arm-lengths. Since the…
Tilt-to-length (TTL) noise induced by angular jitter of spacecraft and test masses can affect the sensitivity of space-based gravitational-wave detectors such as LISA, Taiji, and TianQin. Such angular jitter can be measured using the…
The Taiji mission for space-based gravitational wave (GW) detection employs laser interferometry to measure picometer-scale distance variations induced by GWs. The tilt-to-length (TTL) coupling noise in the inter-spacecraft interferometers,…
LISA Pathfinder is the technological demonstrator space mission for the future gravitational waves observatory in space eLISA, with the aim of measure the differential acceleration between free-falling test masses orbiting in the same…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
The Laser Ranging Interferometer (LRI) instrument on the Gravity Recovery and Climate Experiment (GRACE) Follow-On mission has provided the first laser interferometric range measurements between remote spacecraft, separated by approximately…
Future drag-free missions for space-based experiments in gravitational physics require a Gravitational Reference Sensor with extremely demanding sensing and disturbance reduction requirements. A configuration with two cubical sensors is the…
Laser frequency stabilization is notably one of the major challenges on the way to a space-borne gravitational wave observatory. The proposed Laser Interferometer Space Antenna (LISA) is presently under development in an ESA, NASA…
The drag-free satellites of LISA will maintain the test masses in geodesic motion over many years with residual accelerations at unprecedented small levels and time delay interferometry (TDI) will keep track of their differential positions…
The observation of massive black hole binary systems is one of the main science objectives of the Laser Interferometer Space Antenna (LISA). The instrument's design requirements have recently been revised: they set a requirement at…
Space-based interferometric gravitational wave instruments such as the ESA/NASA Laser Interferometer Space Antenna (LISA) observe gravitational waves by measuring changes in the light travel time between widely-separated spacecraft. One…
Gravitational waves (GWs) produced by sound waves in the primordial plasma during a strong first-order phase transition in the early Universe are going to be a main target of the upcoming Laser Interferometer Space Antenna (LISA)…