Related papers: Nanobeam photonic crystal cavity quantum dot laser
This paper reports on the quasi-three-level continuous wave laser operation based on waveguide structures in neodymium doped calcium niobium gallium garnet disordered crystal. Laser wavelength selection through the waveguide cross section…
Photonic crystal nanobeam cavities are valued for their small mode volume, CMOS compatibility, and high coupling efficiency crucial features for various low-power photonic applications and quantum information processing. However, despite…
GeSn alloys have been regarded as a potential lasing material for a complementary metal-oxide-semiconductor (CMOS)-compatible light source. Despite their remarkable progress, all GeSn lasers reported to date have large device footprints and…
Numerical simulations based on the quantum Langevin equations have been performed for a large number of two-level atoms in a beam interacting with a low-Q cavity with the atomic initial superposition states close to the north pole of the…
When a pump beam is propagating through a silicon nanophotonic waveguide, a very small fraction of the light is scattered to other frequencies. At very low intensity, the amount of scattered light is proportional to the power of the pump…
We investigate the dynamical properties of nanolasers comprising a few two-level emitters coupled to an optical cavity. A set of rate equations is derived, which agree very well with a solution of the full master equation model and makes it…
We measure the lasing dynamics of single and coupled photonic crystal nanocavity array lasers fabricated in the indium gallium arsenide phosphide material system. Under short optical excitation, single cavity lasers produce pulses as fast…
We have developed external-cavity diode lasers, where the wavelength selection is assured by a low loss interference filter instead of the common diffraction grating. The filter allows a linear cavity design reducing the sensitivity of the…
Colloidal semiconductor nanocrystals are promising building blocks for optoelectronics due to their solution processability, spectral tunability, and ability to self-assemble into complex architectures. However, their use in lasing…
Lasing in the bad cavity regime has promising applications in precision metrology due to the reduced sensitivity to cavity noise. Here we investigate the spectral properties and phase behavior of pulsed lasing on the $^1$S$_0 - ^3$P$_1$…
Laser-cooled gases of atoms interacting with the field of an optical cavity are a powerful tool for quantum sensing and the simulation of open and closed quantum systems. They can display spontaneous self-organisation phase transitions,…
We design and fabricate large-area (1.1 mm $\times$ 1.1 mm) photonic crystal quantum cascade lasers, enabling single-mode (wavelength $\sim$ 8.5 $\mu$m) surface emission at room temperature, with a maximum peak power up to 176 mW. The beam…
A photonic crystal (PhC) nanocavity formed in an optically very thick slab can support reasonably high-Q modes for lasing. Experimentally, we demonstrate room-temperature pulsed lasing operation from the PhC dipole mode emitting at 1324 nm,…
We demonstrate an external cavity laser with intrinsic linewidth below 100 Hz around an operating wavelength of 852 nm, selected for its relevance to laser cooling and manipulation of cesium atoms. This system achieves a maximum CW output…
The National Ignition Facility laser focuses 1.8 Mega-joules of ultraviolet light (wavelength 351 nano-meters) from 192 beams into a 600-micro-meter-diameter volume. Effective use of this output in target experiments requires that the power…
Laser trapping near the surface of a nanostructured substrate is demonstrated. Stable microbubbles with radii of 1-20micrometers have been created and manipulated with sub-micron precision by a focused laser beam in an immersion oil…
We experimentally demonstrated high quality factors (Q-factors) of nanocavities in three-dimensional photonic crystals by increasing the in-plane area of the structure. Entire structures made of GaAs were fabricated by a micro-manipulation…
Quantum networks based on InGaAs quantum dots embedded in photonic crystal devices rely on QDs being in resonance with each other and with the cavities they are embedded in. We developed a new technique based on temperature tuning to…
The design of some optical devices such as semiconductor optical amplifiers for telecommunication applications requires polarization-insensitive optical emission at the long wavelengths (1300-1550 nm). Self-assembled InAs/GaAs quantum dots…
Control over the properties of nanoparticles obtained by laser ablation in liquids is experimentally demonstrated via modulation of the beam intensity profile on the target. Mask projection scheme was used with either a copper laser…