Related papers: High Precision MultiWave Rectifier Circuit Operati…
Basing on 2D computer simulation of physical processes in high-voltage reversibly-switched dynistors (RSD) important peculiarities of their submicrosecond pulse performance mechanisms have been studied. It is characteristic that on early…
We propose to realize microwave quantum illumination in weak coupling regime based on multimode optomechanical systems. In our proposal the multimode together with a frequency-mismatch process could reduce mechanical thermal noise.…
We report on a compact, highly sensitive all-fiber accelerometer suitable for low frequency and low amplitude vibration sensing. The sensing elements in the device are two short segments of strongly coupled asymmetric multicore fiber (MCF)…
Millimeter-wave and Terahertz frequencies, while promising high throughput and abundant spectrum, are highly susceptible to hardware non-idealities like phase-noise, which degrade the system performance and make transceiver implementation…
A 5-MeV RFQ designed for a proton current up to 100-mA CW is now under construction as part of the High Intensity Proton Injector project (IPHI). Its computed transmission is greater than 99 %. The main goals of the project are to verify…
We present improved performance for a 92 to 96 GHz cross-spectrum phase modulated (PM) noise measurement system reported. The system is principally designed to measure amplifiers in pulsed mode as well as in CW mode at a given pulse…
We present a novel way of wavefront sensing using a commercially available, continuous-wave time-of-flight camera with QVGA-resolution. This CMOS phase camera is capable of sensing externally modulated light sources with frequencies up to…
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…
Rectification of microwave radiation (20-40 GHz) by a line boundary between two two-dimensional metals on a silicon surface was observed and investigated at different temperatures, in-plane magnetic fields and microwave powers. The…
The quasi-optical modulation of linear polarization at millimeter and sub-millimeter wavelengths can be achieved by using rotating half wave plates (HWPs) in front of polarization sensitive detectors. Large operational bandwidths are…
We report on the design and performance of an on-chip microwave circulator with a widely (GHz) tunable operation frequency. Non-reciprocity is created with a combination of frequency conversion and delay, and requires neither permanent…
The proliferation of small unmanned aerial systems (sUAS) operating under autonomous guidance has created an urgent need for non-kinetic neutralization methods that are immune to conventional radio-frequency jamming. This paper presents a…
Dynamic comparators are an essential part of low-power analog to digital converters (ADCs) and are referred to as one of the most important building blocks in mixed mode circuits. The power consumption and accuracy of dynamic comparators…
We present the design process and implementation of fully open-source, ultra-low noise programmable current source systems in two configurations. Although originally designed as coil drivers for Optically Pumped Magnetometers (OPMs), the…
An ultra-low-voltage crystal quartz oscillator is proposed. The approach to its design is essentially based on using a HEMT operating in unsaturated dc regime and a quartz resonator as a resonant impedance transformer. The 25 MHz prototype…
Spin-diodes are usually resonant in nature (GHz frequency) and tuneable by magnetic field and bias current with performances, in terms of sensitivity and minimum detectable power, overcoming the semiconductor counterpart, i.e. Schottky…
In this article, we investigate channel estimation for wideband millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) under hybrid architecture with lowprecision analog-to-digital converters (ADCs). To design channel…
Far-field Wireless Power Transfer (WPT) has attracted significant attention in the last decade. Recently, channel-adaptive waveforms have been shown to significantly increase the DC power level at the output of the rectifier. However the…
Cavity combiners have been put forward for high power combining due to their advantages of larger combining ability, variable input channels and less power loss. For a high power cavity combiner, it is better to keep the power loss ratio in…
This paper proposes a dynamic capacitance matching (DCM)-based RC current response algorithm for calculating the current waveform of a signal line without performing SPICE simulation. Specifically, unlike previous method such as CCS model,…