Related papers: An IR Photodetector Using an Optically Cooled Micr…
We report on a non-interacting technique for thermal characterization of fluids based on surface plasmon resonance interrogation. Using liquid volumes less than 20 micro liters we have determined the materials' thermo-optic coefficients…
Photo-induced forces can be used to manipulate and cool the mechanical motion of oscillators. When the oscillator is used as a force sensor, such as in atomic force microscopy, active feedback is an enticing route to enhancing measurement…
Squeezed states of light reduce the signal-normalized photon counting noise of measurements without increasing the light power and enable fundamental research on quantum entanglement in hybrid systems of light and matter. Furthermore, the…
The integration of photonic sensors into microfluidic devices provides opportunities for dynamic measurement of chemical and physical properties of fluids in very small volumes. We previously reported on the use of commercially available…
Thermal detectors are a powerful instrument for the search of rare particle physics events. Inorganic crystals are classically used as thermal detectors held in supporting frames made of copper. In this work a novel approach to the…
We propose an experiment using optically trapped and cooled dielectric microspheres for the detection of short-range forces. The center-of-mass motion of a microsphere trapped in vacuum can experience extremely low dissipation and quality…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
Highly coherent mechanical resonators are invaluable to ultrasensitive detection techniques by enabling detection of small forces. Studying mechanical resonators in a thermal equilibrium state at millikelvin temperatures provides a…
We present the design of a continuous-wave, highly sensitive optical spectrometer for millimeter-wave frequencies between 50 and 1000 GHz. The spectrometer uses photomixing of near-infrared light to generate radiation in a wide frequency…
This paper demonstrates cooling of the center-of-mass motion of 10 $\mu$m-diameter optically levitated silica spheres to an effective temperature of $50\pm22 \mu$K, achieved by minimizing the technical pointing noise of the trapping laser.…
Squeezed light is a useful phenomenon that can be exploited to improve the sensitivity of specific classes of detectors based on optomechanical effects. Recently, there has been significant interest in the potential application of a…
Spectroscopy and imaging in the mid-infrared (2.5 $\mu$m $\sim$ $\lambda$ $\sim$ 25 $\mu$m) is bedevilled by the presence of a strong 300 K thermal background at room temperature that makes IR detectors decades noisier than can be readily…
We demonstrate AFM imaging with a microcantilever force transducer where an integrated superconducting microwave resonant circuit detects cantilever deflection using the principles of cavity optomechanics. We discuss the detector…
Optomechanical systems are promising platforms for controlled light-matter interactions. They are capable of providing several fundamental and practical novel features when the mechanical oscillator is cooled down to nearly reach its ground…
Resistance thermometry provides a time-tested method for taking temperature measurements. However, fundamental limits to resistance-based approaches has produced considerable interest in developing photonic temperature sensors to leverage…
We cool the fundamental mechanical mode of an ultrasoft silicon cantilever from a base temperature of 2.2 K to 2.9 +/- 0.3 mK using active optomechanical feedback. The lowest observed mode temperature is consistent with limits determined by…
We have designed and implemented a straightforward method to deterministically measure the temperature of the selected segment of a cold atom ensemble, and we have also developed an upgrade in the form of nondestructive thermometry. The…
Optical beam deflection is a popular method to measure the deformation of micromechanical devices. As it measures mostly a local slope, its sensitivity depends on the location and size of the optical spot. We present a method to evaluate…
Optomechanical transduction harnesses the interaction between optical fields and mechanical motion to achieve sensitive measurement of weak mechanical quantities with inherently low noise. Lithium niobate combines low optical loss, strong…
Silicon's bandgap inherently restricts its photodetection to wavelengths below 1100 nm, necessitating the integration of costly III-V semiconductors for short-wave infrared applications. Hyperdoping silicon beyond the solid solubility limit…