Related papers: Cavity optomechanics with stoichiometric SiN films
An integrated photonic platform is proposed for strong interactions between atomic beams and annealing-free high-quality-factor (Q) microresonators. We fabricated a thin-film, air-clad SiN microresonator with a loaded Q of $1.55\times10^6$…
The sensitivity in interferometric measurements such as gravitational-wave detectors is ultimately limited by quantum noise of light. We discuss the use of feedback mechanisms to reduce the quantum effects of radiation pressure. Recent…
Optical microcavities allow to strongly confine light in small mode volumes and with long photon lifetimes. This confinement significantly enhances the interaction between light and matter inside the cavity, with applications such as…
One of the most fundamental problems in optomechanical cooling is how small the thermal phonon number of a mechanical oscillator can be achieved under the radiation pressure of a proper cavity field. Different from previous theoretical…
We report disk-shaped silicon optomechanical resonators with frequency up to 1.75 GHz in the ultrahigh frequency band. Optical transduction of the thermal motion of the disks' in-plane vibrational modes yields a displacement sensitivity of…
Multimode optomechanical systems are an emerging platform for studying fundamental aspects of matter near the quantum ground state and are useful in sensitive sensing and measurement applications. We study optomechanical cooling in a system…
Optomechanical cavities in the well-resolved-sideband regime are ideally suited for the study of a myriad of quantum phenomena with mechanical systems, including backaction-evading measurements, mechanical squeezing, and generation of…
Multimode cavity optomechanics, where multiple mechanical degrees of freedom couple to optical cavity modes, provides a rich platform for exploring nonlinear dynamics and engineering complex interactions. In this work, we investigate the…
We present an approach to mitigate coating thermal noise in optical cavities by using multiple TEM spatial modes to readout and stabilize laser frequency. With optimal weightings we synthesize a wider sampling of the mirror surface,…
Studying the interplay between multiple coupled mechanical resonators is a promising new direction in the field of optomechanics. Understanding the dynamics of the interaction can lead to rich new effects, such as enhanced coupling and…
We carry out analysis of optomechanical system formed by moveable mirror of Fabry-Perot cavity pumped by detuned laser. Optical spring arising from detuned pump creates in the system several eigen modes which could be treated as high-Q…
We report the experimental observation of a magnetic-field-tuned superconductor-insulator transition (SIT) in ultrathin TiN films. The low temperature transport properties of these films show scaling behavior consistent with a transition…
B20-type MnSi is the prototype magnetic skyrmion material. Thin films of MnSi show a higher Curie temperature than their bulk counterpart. However, it is not yet clear what mechanism leads to the increase of the Curie temperature. In this…
Conventional techniques for laser cooling, by coherent scattering off of internal states or through an optical cavity mode, have so far proved inefficient on mechanical oscillators heavier than a few nanograms. That is because larger…
Coupling mechanical motion to an optical resonator enables displacement measurements approaching the standard quantum limit (SQL). However, increasing the optomechanical coupling strength will inevitably lead to probing of the nonlinear…
Here we present a magnetic thin film with a weak ferrimagnetic (FIM) phase above the N\'eel temperature ($T_{N}$ = 240 K) and a non-collinear antiferromagnetic (AFM) phase below, exhibiting a small net magnetisation due to strain-associated…
We demonstrate the use of a compound optical cavity as linear displacement detector, by measuring the thermal motion of a silicon nitride suspended membrane acting as the external mirror of a near-infrared Littrow laser diode. Fluctuations…
Due to their exceptional plasmonic properties, noble metals such as gold and silver have been the materials of choice for the demonstration of various plasmonic and nanophotonic phenomena. However, noble metals' softness, lack of…
We have grown superconducting TiN films by atomic layer deposition with thicknesses ranging from 6 to 89 nm. This deposition method allows us to tune the resistivity and critical temperature by controlling the film thickness. The microwave…
Optomechanical systems are promising platforms for controlled light-matter interactions. They are capable of providing several fundamental and practical novel features when the mechanical oscillator is cooled down to nearly reach its ground…