Related papers: ADC non-linear errors correction in thermal diagno…
High-resolution temperature measurements are required in the LTP, i.e., 10 uK/sqrt(Hz) from 1 mHz to 30 mHz. This has been already accomplished with thermistors and a suitable low noise electronics. However, the frequency range of interest…
LISA Pathfinder (LPF) was a technology pioneering mission designed to test key technologies required for gravitational wave detection in space. In the low frequency regime (milli-Hertz and below), where space-based gravitational wave…
Noise measurements have been carried out in the LISA bandwidth (0.1 mHz to 100 mHz) to characterize an all-optical atomic magnetometer based on nonlinear magneto-optical rotation. This was done in order to assess if the technology can be…
Temperature fluctuations are expected to be one of the limiting factors for gravitational wave detectors in the very low frequency range. Here we report the characterisation of this noise source in the LISA Pathfinder optical bench and…
During the On-Station Thermal Test campaign of the LISA Pathfinder the data and diagnostics subsystem was tested in nearly space conditions for the first time after integration in the satellite. The results showed the compliance of the…
LISA PathFinder (LPF) will be flown with the objective to test in space key technologies for LISA. However its sensitivity goals are, for good reason, one order of magnitude less than those which LISA will have to meet, both in drag-free…
The LISA mission is a space interferometer aiming at the detection of gravitational waves in the [$10^{-4}$,$10^{-1}$] Hz frequency band. In order to reach the gravitational wave detection level, a Time Delay Interferometry (TDI) method…
LISA is an upcoming ESA mission that will detect gravitational waves in space by interferometrically measuring the separation between free-falling test masses at picometer precision. To reach the desired performance, LISA will employ the…
We anticipate noise from the Laser Interferometer Space Antenna (LISA) will exhibit nonstationarities throughout the duration of its mission due to factors such as antenna repointing, cyclostationarities from spacecraft motion, and glitches…
We propose a new method to measure the system noise temperature, $T_{\rm sys}$, using a 2-bit analog-to-digital converter (ADC). The statistics of the digitized signal in a four-level quantization brings us information about the bias…
Time-delay interferometry (TDI) is a post-processing technique used to reduce laser noise in heterodyne interferometric measurements with unequal armlengths, a situation characteristic of space gravitational detectors such as Laser…
The Laser Interferometer Space Antenna (LISA) mission aims to detect gravitational waves by interferometrically measuring the change of separation between free-falling test masses (TMs). LISA's interferometers must deliver pm/rtHz…
We present recent sensitivity measurements of the LISA Technology Package interferometer with articulated mirrors as test masses, actuated by piezo-electric transducers. The required longitudinal displacement resolution of 9 pm/sqrt[Hz]…
This paper reports on the methods and results of a theoretical analysis to design an insulator which must provide a thermally quiet environment to test on ground delicate temperature sensors and associated electronics. These will fly on…
LISA is a joint space mission of the ESA and NASA for detecting low frequency gravitational radiation in the band $10^{-5} - 1$ Hz. In order to attain the requisite sensitivity for LISA, the laser frequency noise must be suppressed below…
Tilt-to-length (TTL) noise from angular jitter in LISA is projected to be the dominant noise source in the milli-Hertz band unless corrected in post-processing. The correction is only possible after removing the overwhelming laser phase…
The Laser Interferometer Space Antenna (LISA) mission features a three-spacecraft long-arm constellation intended to detect gravitational wave sources in the low-frequency band up to 1 Hz via laser interferometry. The paper presents an…
In order to attain the requisite sensitivity for LISA - a joint space mission of the ESA and NASA- the laser frequency noise must be suppressed below the secondary noises such as the optical path noise, acceleration noise etc. By combining…
One of the atom interferometer gravitational wave missions proposed by Dimopoulos et al.1 in 2008 was called AGIS-Sat. 2. It had a suggested gravitational wave sensitivity set by the atom state detection shot noise level that started at 1…
The LTP (LISA Testflight Package), to be flown aboard the ESA / NASA LISA Pathfinder mission, aims to demonstrate drag-free control for LISA test masses with acceleration noise below 30 fm/s^2/Hz^1/2 from 1-30 mHz. This paper describes the…