Related papers: ADC non-linear errors correction in thermal diagno…

A tabletop low-noise differential amplifer with a bandwidth of 100 kHz is presented. Low voltage drifts of the order of 100 nV/day are reached by thermally stabilizing relevant amplifer components. The input leakage current is below 100 fA.…

The sensitivity of LISA depends on the suppression of several noise sources; dominant one is laser frequency noise. It has been shown that the six Doppler data streams obtained from three space-crafts can be appropriately time delayed and…

We describe a set up for measurements of low frequency (1 mHz < f < 20 Hz) conductance fluctuations in a solid conductor. The set-up uses a five probe a.c. measurement technique and extensive digital signal processing to reach a noise floor…

The Laser Interferometer Space Antenna (LISA) will be the first space-based gravitational wave (GW) observatory. It will measure gravitational wave signals in the frequency regime from 0.1 mHz to 1 Hz. The success of these measurements will…

Time delay interferometry (TDI) is a post-processing technique used in the Laser Interferometer Space Antenna (LISA) to reduce laser frequency noise by building an equal-arm interferometer via combining time-shifted raw phase measurements.…

The orbiting LISA instrument is designed to detect gravitational waves in the millihertz band, produced by sources including galactic binaries and extreme mass ratio inspirals, among others. The detector consists of three spacecraft, each…

The proposed Laser Interferometer Space Antenna (LISA) mission is tasked with the detection and characterization of gravitational waves from various sources in the universe. This endeavor is challenged by transient displacement and…

Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…

This paper presents a low-noise amplifier (LNA) that was developed for a new radio telescope comprised of 512 parabolic dish antennas. The LNA closely interfaces to a custom-made antenna feed with an impedance co-designed to provide noise…

Three spacecraft of LISA/TAIJI mission follow their respective geodesic trajectories, and their interferometric arms are unequal and time-varying due to orbital dynamics. Time-delay interferometry (TDI) is proposed to suppress the laser…

LISA is the proposed ESA-NASA gravitational wave detector in the 0.1 mHz - 0.1 Hz band. LISA Pathfinder is the down-scaled version of a single LISA arm. The arm -- named Doppler link -- can be treated as a differential accelerometer,…

This paper presents a quantitative assessment of the performance of the upcoming LISA Pathfinder geodesic explorer mission. The findings are based on the results of extensive ground testing and simulation campaigns using flight hardware and…

Laser Interferometer Space Antenna LISA represents the next frontier in gravitationalwave GW astronomy targeting the detection of millihertz gravitational signals Central to LISAs operation is the nanosecondprecision estimation of the light…

The tilt-to-length coupling during the LISA Pathfinder mission has been numerically and analytically modeled for particular timespans. In this work, we investigate the long-term stability of the coupling coefficients of this noise. We show…

We describe the design and performance of a series of fast, precise current sensing noise thermometers. The thermometers have been fabricated with a range of resistances from 1.290 $\Omega$ down to 0.2 m$\mathrm{\Omega}$. This results in…

Far-infrared detectors for future cooled space telescopes require ultra-sensitive detectors with optical noise equivalent powers of order 0.2 aW/\sqrt Hz. This performance has already been demonstrated in arrays of transition edge sensors.…

In this paper a new design of MMIC based LNA is outlined. This design uses a discrete 100-nm InP HEMT placed in front of an existing InP MMIC LNA to lower the overall noise temperature of the LNA. This new approach known as the Transistor…

Precision phase readout of optical beat note signals is one of the core techniques required for intersatellite laser interferometry. Future space based gravitational wave detectors like eLISA require such a readout over a wide range of MHz…

This document briefly describes the noise models and shapes used for the synthesis of the Drag-Free and Attitude Control System in the LISA space mission. LISA (Laser Interferometer Space Antenna) is one of the next large-class missions…

We describe the development of a noise-temperature testing capability for phased-array antennas operating in receive mode from 0.7 GHz to 1.8 GHz. Sampled voltages from each array port were recorded digitally as the zenith-pointing array…