Related papers: Manipulating Spins by Cantilever Synchronized Freq…
In this work we introduce a new method of a ferromagnetic resonance (FMR) detection from thin, nm-size, films. Our setup is based on the commercial piezo-cantilever, used for atomic force microscopy. It has an option to rotate the sample in…
A method to precisely calibrate the oscillation amplitude in Dynamic Scanning Force Microscopy is described. It is experimentally shown that a typical electronics used to process the dynamic motion of the cantilever can be adjusted to…
We recently introduced a new theoretical description of Landau--Zener--St\"{u}ckelberg--Majorana (LZSM) transitions that accounts for both adiabatic and spin-dephasing losses during sweeps through resonance. Here, we use this new…
Frequency dependent dynamic behavior in Piezoresponse Force Microscopy (PFM) implemented on a beam-deflection atomic force microscope (AFM) is analyzed using a combination of modeling and experimental measurements. The PFM signal comprises…
We demonstrate an alternative to Kelvin Probe Force Microscopy for imaging surface potential. The open-loop, single-pass technique applies a low-frequency AC voltage to the atomic force microscopy tip while driving the cantilever near its…
Magnetic Resonance Force Microscopy can enable nanoscale imaging of spin lifetime. We report temperature dependent measurements of the spin correlation time $\tau_m$ of the statistical fluctuations of the spin polarization---the spin…
We present a rotary-stage microwave probe station suitable for magnetic films and spintronic devices. Two stages, one for field rotation from parallel to perpendicular to the sample plane (Out-of-Plane) and the other intended for field…
Using a Magnetic Resonace Force Microscope, we have performed ferromagnetic resonance (FMR) spectroscopy on parametric magnons created by 4-wave process. This is achieved by measuring the differential response to a small source modulation…
The torsional vibration of atomic force microscope (AFM) cantilevers is critical for high-sensitivity measurements, yet existing models for width-varying cantilevers often rely on approximations that lead to significant discrepancies with…
Magnetic tunnel junctions (MTJs) are key enablers of spintronic technologies used in a variety of applications including information storage, microwave generation and detection, as well as unconventional computing. Here, we present…
Various methods of force measurement with the Atomic Force Microscope (AFM) are compared for their ability to accurately determine the tip-surface force from analysis of the nonlinear cantilever motion. It is explained how intermodulation,…
We report the development of the frequency-modulation (FM) method for measuring electron spin resonance (ESR) absorption in the 210-420 GHz frequency range. We demonstrate that using a high-frequency ESR spectrometer without resonating…
We analyze a single-spin measurement using a transient process in magnetic force microscopy (MFM) which could increase the maximum operating temperature by a factor of Q (the quality factor of the cantilever) in comparison with the static…
Mechanical resonators operating in the high-frequency regime have become a versatile platform for fundamental and applied quantum research. Their exceptional properties, such as low mass and high quality factor, make them also very…
Using micromagnetics we demonstrate that the r.f. field produced by a spin valve can be used to reverse the magnetization in a magnetic nanoparticle. The r.f. field is generated using a current that specifically excites a uniform spin wave…
Magnetic force microscopy (MFM) is a well-established technique in scanning probe microscopy that allows for the imaging of magnetic samples with a spatial resolution of tens of nm and stray fields down to the mT range. The spatial…
A simple strobe setup with potential to study higher-order eigenmodes and multifrequency oscillations in micromechanical resonators is described. It requires standard equipment, commonly found in many laboratories, and it can thus be…
Frequency multiplication involves generating harmonics from an input frequency, a technique particularly useful for integrating spin-wave devices operating at different frequencies. While topological magnetic textures offer distinct…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
We analyze the back-action influence of nuclear spins on the motion of the cantilever of a magnetic force resonance microscope. We calculate the contribution of nuclear spins to the damping and frequency shift of the cantilever. We show…