Related papers: Design and Implementation of the New D0 Level-1 Ca…
Two MiniPlug calorimeters, designed to measure the energy and lateral position of particles in the (forward) pseudorapidity region of $3.6<|\eta|<5.2$ of the CDF detector, have been recently installed as part of the Run II CDF upgrade at…
One of the main goals of the Tevatron RunII is to look for any hints for new physics. At D0, the range of searches for new physics signals is large and one of the places we look for hints for new physics is by measuring the top quark…
The ATLAS Trigger system is a key component of the ATLAS experiment at the CERN Large Hadron Collider (LHC), designed to reduce the event rate from the 40 MHz proton-proton bunch crossing frequency to an output suitable for offline storage…
At the start of Run 2 in 2015, the LHC delivered proton-proton collisions at a center-of-mass energy of 13 TeV. During Run 2 (years 2015-2018) the LHC eventually reached a luminosity of 2.1 $\times$ 10$^{34}$ cm$^{-2}$ s$^{-1}$, almost…
The Mu2e experiment at Fermilab aims at measuring the neutrinoless conversion of a negative muon into an electron and reach a single event sensitivity of 2.5x10^{-17} after three years of data taking. The monoenergetic electron produced in…
The CALICE collaboration is developing an engineering prototype of an analog hadron calorimeter for a future linear collider detector. The prototype has to prove the feasibility of building a realistic detector with fully integrated…
To evaluate different technologies for calorimetry at the International Linear Collider, the CALICE collaboration has constructed a highly granular analog hadron calorimeter with small scintillator cells, individually read out by silicon…
The electronic system developed for the SpaCal lead/scintillating-fibre calorimeters of the H1 detector in operation at the HERA ep collider is described in detail and the performance achieved during H1 data-taking is presented. The 10 MHz…
We discuss possibilities of detecting neutral and charged long-lived particles with the upgraded D0 detector in Run II of the Fermilab Tevatron accelerator, using photon pointing, dE/dx, and time-of-flight techniques. Such particles appear…
The Compact Muon Solenoid (CMS) calorimeter regional trigger system is designed to detect signatures of isolated and non-isolated electrons/photons, jets, ?-leptons, and missing and total transverse energy using a deadtimeless pipelined…
Design of new experiments, as well as upgrade of ongoing ones, is a continuous process in the experimental high energy physics. Since the best solution is a trade-off between different kinds of limitations, a quick turn over is necessary to…
LHCb is a general purpose forward detector located at the Large Hadron Collider (LHC) at CERN. Although initially optimized for the study of hadrons containing beauty quarks, the better than expected performance of the detector hardware and…
Measuring the region $0.1 < Q^{2} < 1.0$ GeV$^{2}$ is essential to support searches for gluon saturation at the future Electron-Ion Collider. Recent studies have revealed that covering this region at the highest beam energies is not…
The CDF and D0 collaborations at Fermilab's Tevatron p-pbar collider have in place an extensive program to measure fundamental properties of the top quark. Recent results from Run I (sqrt-s = 1.8 TeV) and Run II (sqrt-s = 1.96 TeV) on the…
The Fermilab Tevatron collider's data-taking run ended in September 2011, yielding a dataset with rich scientific potential. The CDF and D0 experiments each have approximately 9 PB of collider and simulated data stored on tape. A large…
We present a comprehensive review of the physics results obtained by the CDF and D0 collaborations up to summer 2014, with emphasis on those achieved in the Run II of the Tevatron collider which delivered a total integrated luminosity of…
The SiD Detector is one of two detector designs for the future International Linear Collider (ILC) that were validated in 2012 SiD features a compact, cost-constrained design for precision Higgs and other measurements, and sensitivity to a…
The LHCb detector optimised its performance in Runs~1 and~2 by stabilising the instantaneous luminosity during a fill. This was achieved by tuning the distance between the two colliding beams according to the measurement of instantaneous…
The multilevel trigger system of the DIRAC experiment at CERN is presented. It includes a fast first level trigger as well as various trigger processors to select events with a pair of pions having a low relative momentum typical of the…
The commissioning of two cryomodule components is underway at Fermilab's Superconducting Radio Frequency (SRF) Accelerator Test Facility. The research at this facility supports the next generation high intensity linear accelerators such as…