Related papers: Improving the sensitivity of FM spectroscopy using…
High-frequency atomic force microscopy has enabled extraordinary new science through large bandwidth, high speed measurements of atomic and molecular structures. However, traditional optical detection schemes restrict the dimensions, and…
Nanomechanical resonator-based sensing devices are used in medical diagnostics based on their high-frequency dynamic behavior. Cantilevers fall into the category of Nanomechanical resonators. It also resembles a resonator whose shape is…
Nanometer-scale structures with high aspect ratio such as nanowires and nanotubes combine low mechanical dissipation with high resonance frequencies, making them ideal force transducers and scanning probes in applications requiring the…
Dynamic-mode atomic force microscopy (AFM) in liquid remains complicated due to the strong viscous damping of the cantilever resonance. Here we show that a high-quality resonance (Q>20) can be achieved in aqueous solution by attaching a…
The future laser interferometric gravitational-wave detectors sensitivity can be improved using squeezed light. In particular, recently a scheme which uses the optical field with frequency dependent squeeze factor, prepared by means of a…
We report on the design, fabrication, and implementation of ultrasensitive micromechanical oscillators. Our ultrathin single-crystal silicon cantilevers with integrated magnetic structures are the first of their kind: They are fabricated…
Nanolasers are considered ideal candidates for communications and data processing at chip-level thanks to their extremely reduced footprint, low thermal load and potentially outstanding modulation bandwidth, which in some case has been…
The sensitivity of mechanical resonators to physical quantities such as acceleration, pressure, mass and temperature enables them to underpin sensing and metrology applications. Here, we observe that the resonance frequency of a…
We determine the quantum mechanical limits to inertial mass-sensing based on nanomechanical systems. We first consider a harmonically oscillating cantilever whose vibration frequency is changed by mass accretion at its surface. We show that…
The displacement of micro-electro-mechanical-systems (MEMS) cantilevers is used to measure a broad variety of phenomena in devices ranging from force microscopes to biochemical sensors to thermal imaging systems. We demonstrate the first…
The extensive research and development of micromechanical resonators is trying to allow the use of these devices for highly sensitive applications. Microcantilevers are some of the simplest MEMS structure and had been proved to be a good…
When measuring quadratic values representative of random fluctuations, such as the thermal noise of Atomic Force Microscopy (AFM) cantilevers, the background measurement noise cannot be averaged to zero. We present a signal processing…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
The purpose of a phase-preserving linear amplifier is to make a small signal larger, regardless of its phase, so that it can be perceived by instruments incapable of resolving the original signal, while sacrificing as little as possible in…
Nano- and micromechanical oscillators with high quality (Q) factors have gained much attention for their potential application as ultrasensitive detectors. In contrast to micro-fabricated devices, optically trapped nanoparticles in vacuum…
We introduce wavefront shaping as a tool for optimizing the sensitivity in nano-optomechanical measurement schemes. We perform multimode output analysis of an optomechanical system consisting of a focused laser beam coupled to the…
An opto--electro--mechanical system formed by a nanomembrane capacitively coupled to an LC resonator and to an optical interferometer has been recently employed for the high--sensitive optical readout of radio frequency (RF) signals [T.…
We study the opportunity to reduce a magnetic noise produced by a uniform cantilever with a ferromagnetic particle in magnetic resonance force microscopy (MRFM) applications. We demonstrate theoretically a significant reduction of magnetic…
We present a "nanoladder" geometry that minimizes the mechanical dissipation of ultrasensitive cantilevers. A nanoladder cantilever consists of a lithographically patterned scaffold of rails and rungs with feature size $\sim$ 100 nm.…
We demonstrate AFM imaging with a microcantilever force transducer where an integrated superconducting microwave resonant circuit detects cantilever deflection using the principles of cavity optomechanics. We discuss the detector…