Related papers: Optimization of thermal noise in multi-loop pendul…
A four mass torsion pendulum facility for testing of the LISA GRS is under development in Trento. With a LISA-like test mass suspended off-axis with respect to the pendulum fiber, the facility allows for a direct measurement of surface…
The modeling of intrinsic noise in pulsar timing residual data is of crucial importance for Gravitational Wave (GW) detection and pulsar timing (astro)physics in general. The noise budget in pulsars is a collection of several well studied…
We present measurements of the dynamical response of thermal noise to an ac excitation in conductors at low temperature. From the frequency dependence of this response function - the noise thermal impedance - in the range 1 kHz-1 GHz we…
We show that the spatial structure of electromagnetic vacuum fluctuations, predicted by quantum electrodynamics, can be indirectly observed using thermal noise at radio frequencies. Using simple lab equipment like coaxial cables and RF…
Measurement of interferometric parameters values is affected by phase disturbance due especially to atmospheric turbulences. Algorithms of fringe sensing, aimed at fringe parameters identification, are based on interferometric models that…
Motional heating of ions in micro-fabricated traps is a challenge hindering experimental realization of large-scale quantum processing devices. Recently a series of measurements of the heating rates in surface-electrode ion traps…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
Interferometric detection of mirror displacements is intrinsically limited by laser shot noise. In practice, however, it is often limited by thermal noise. Here we report on an experiment performed at the liquid helium temperature to…
In order to expand the astrophysical reach of gravitational wave detectors, several interferometer topologies have been proposed to evade the thermodynamic and quantum mechanical limits in future detectors. In this work, we make a…
The fundamental features of the detection of non-stationary undulatory perturbations of metrics based on the interference effects are considered. The advantage of the Aharonov-Bohm effect in superconductors for these purposes in comparison…
In order to stabilize the behavior of noisy systems, confining it around a desirable state, an effort is required to suppress the intrinsic noise. This noise suppression task entails a cost. For the important case of thermal noise in an…
Test-mass thermal noise is a limiting noise source for current and next-generation ground-based gravitational-wave observatories. Uniform-intensity higher-order laser beams, including Laguerre-Gaussian (LG) and Hermite-Gaussian (HG) modes,…
The contribution to the low frequency internal friction and the thermal conductivity due to optically vibrating edge dislocation dipoles is calculated within the modified Granato-Lucke string model. The results are compared with the recent…
Low mechanical loss materials are needed to further decrease thermal noise in upcoming gravitational wave detectors. We present an analysis of the contribution of Akhieser and thermoelastic damping on the experimental results of resonant…
We develop a theory to address the non-equilibrium dynamics of phonons in a one-dimensional trapped ion system. We elaborate our earlier results obtained in Phys. Rev. Lett. {\bf 111}, 170406 (2013) to chart out the mechanism of…
The test masses in next-generation gravitational-wave interferometers may have a semiconductor substrate, most likely silicon. The stochastic motion of charge carriers within the semiconductor will cause random fluctuations in the…
We construct a model for the angular power spectrum of the instrumental noise in interferometer networks mapping gravitational wave backgrounds (GWBs) as a function of detector noise properties, network configuration and scan strategy. We…
Colloidal probes are often used in force microscopy when the geometry of the tip-sample interaction should be well controlled. Their calibration requires the understanding of their mechanical response, which is very sensitive to the details…
The paper describes a method for measuring the thermal diffusivity of materials having a high thermal conductivity. The apparatus is rather simple and low-cost, being therefore suitable in a laboratory for undergraduate students of…
We report on residual gas damping of the motion of a macroscopic test mass enclosed in a nearby housing in the molecular flow regime. The damping coefficient, and thus the associated thermal force noise, is found to increase significantly…