Related papers: Performance of the CDF Calorimeter Simulation in T…
This article reports the laser calibration of the hadronic Tile Calorimeter of the ATLAS experiment in the LHC Run 2 data campaign. The upgraded Laser II calibration system is described. The system was commissioned during the first LHC Long…
These proceedings outline steps toward a systematic analysis of frontier energy collider data: specifically, those data collected at Tevatron Runs I and II, LEP Run II, HERA Runs I and II, and the future LHC. Algorithms designed to…
The CDF inclusive jet transverse energy cross section at 1.8 TeV suggests anomalous behavior at both low and high transverse energies. In addition the scaled ratio of the 0.63 TeV to 1.8 TeV data lies significantly below the standard model…
One of the most important requirements for a detector at the ILC is good jet energy resolution. It is widely believed that the particle flow approach to calorimetry is the key to achieving the ILC goal of a di-jet invariant mass resolution…
We report on a study of jet shapes in inclusive jet production in $p \bar{p}$ collisions at $\sqrt{s} = 1.96 {\rm TeV}$ using the upgraded Collider Detector at Fermilab in Run II (CDF II) based on an integrated luminosity of $170 \rm…
The precise modeling of subatomic particle interactions and propagation through matter is paramount for the advancement of nuclear and particle physics searches and precision measurements. The most computationally expensive step in the…
CMS calorimeter energy calibration was done in the full CMS simulated geometry for the pseudorapidity region eta = 0. The samples of single pion events were generated with a set of incident energies from 5 GeV to 3 TeV and for single…
We discuss recent results obtained by the D0 experiment at the Fermilab Tevatron $p\bar p$ collider and recent combinations of CDF and D0 measurements. Regarding the top quark mass, we present recent measurements obtained at D0, the final…
The Tile Calorimeter is the hadron calorimeter covering the central region of the ATLAS experiment at the Large Hadron Collider. Approximately 10000 photomultipliers collect light from scintillating tiles acting as the active material…
We describe the design and performance the calorimeter systems used in the ECCE detector design to achieve the overall performance specifications cost-effectively with careful consideration of appropriate technical and schedule risks. The…
The phenomenology of b-production and some of the previous Run I measurements of CDF and D0 are briefly reviewed. A new analysis by CDF of Run I b-bbar angular correlations and a new measurement by D0 of Run II b-jet cross-section, are…
For data collected with the CDF Run II detector, measurements of the charm and bottom production cross-sections are presented. The results are based both on large samples of fully reconstructed hadron decay products of charm and bottom made…
A new method for calibrating the hadron response of a segmented calorimeter is developed and successfully applied to beam test data. It is based on a principal component analysis of energy deposits in the calorimeter layers, exploiting…
Recent measurements in the top quark sector at the Fermilab Tevatron collider are discussed. Measurements at the Tevatron use up to 9.7/fb of data corresponding to the full data sets recorded by the CDF and D0 experiments, respectively.…
A single calorimeter station for the Muon $g-2$ experiment at Fermilab includes the following subsystems: a 54-element array of PbF$_{2}$ Cherenkov crystals read out by large-area SiPMs, bias and slow-control electronics, a suite of 800…
Four years after the shutdown of the Tevatron proton-antiproton collider, the two Tevatron experiments, CDF and DZero, continue producing important results that test the theory of the strong interaction, Quantum Chromodynamics (QCD). The…
The HL-LHC and the corresponding detector upgrades for the CMS experiment will present extreme challenges for the full simulation. In particular, increased precision in models of physics processes may be required for accurate reproduction…
The CALICE collaboration has constructed highly granular electromagnetic and hadronic calorimeter prototypes to evaluate technologies for the use in detector systems at the future International Linear Collider. These calorimeters have been…
The Tevatron in Collider Run II (2001-present) is operating with six times more bunches and many times higher beam intensities and luminosities than in Run I (1992-1995). Beam diagnostics were crucial for the machine start-up and the…
We review the most recent measurements of the top quark mass using data collected by the CDF experiment at the Tevatron 1.96 TeV ppbar collider. The mass measurements are performed in all main decay modes of the produced ttbar pairs using…