Related papers: Design and Performance of the CMS Pixel Detector R…

Depleted CMOS active sensors (DMAPS) are being developed for high-energy particle physics experiments in high radiation environments, such as in the ATLAS High Luminosity Large Hadron Collider (HL-LHC). Since charge collection by drift is…

This work is proposing and exploring the use of multichannel readout electronics, already used in quality assurance for gain uniformity studies, to measure the uniformity of the induction gap in GEM based detectors. The measurement will…

The two innermost layers of the ALICE inner tracking system are instrumented with silicon pixel detectors. Single chip assembly prototypes of the ALICE pixels have been tested in high energy particle beams at the CERN SPS. Detection…

The basic principle of operation of silicon sensors with resistive read-out is built-in charge sharing. Resistive Silicon Detectors (RSD, also known as AC-LGAD), exploiting the signals seen on the electrodes surrounding the impact point,…

In order to take full advantage of the U.S. Department of Energy's billion-dollar investments into the next-generation research infrastructure (e.g., exascale, light sources, colliders), advances are required not only in detector technology…

The Micro Pixel Chamber (mu-PIC) using resistive electrodes has been developed and tested. The surface cathodes are made from resistive material, by which the electrical field is reduced when large current is flowed. Two-dimensional…

Flash memories intended for SSD and mobile applications need to provide high random I/O performance. This requires using efficient schemes for reading small chunks of data (e.g. 0.5KB - 4KB) from random addresses. Furthermore, in order to…

High-voltage CMOS (HV-CMOS) pixel technology is being considered for future Higgs factory experiments. The ATLASPix3.1 chip, with a pitch of 50$\mu m$ x 150$\mu m$, fabricated using TSI 180nm HV-CMOS technology, is a full reticle-size…

Optical readout of large Time Projection Chambers (TPCs) with multiple Gas Electron Multipliers (GEMs) amplification stages has shown to provide very interesting performances for high energy particle tracking. Proposed applications for…

The High Luminosity upgrade of the CERN Large Hadron Collider (HL-LHC) requires new high-radiation tolerant silicon pixel sensors for the innermost part of the tracking detector in the CMS experiment. The innermost layer of the tracker,…

This paper describes a highly integrated, low power chip solution for ECG signal processing in wearable devices. The chip contains an instrumentation amplifier with programmable gain, a band-pass filter, a 12-bit SAR ADC, a novel QRS…

The CMS Silicon Strip tracker is a very large scale tracker entirely based on silicon strip detectors technology. The integration of modules, electronics, mechanics and services has been completed within the last eighteen months; first…

This article presents the readout electronics of a novel beam monitoring system for ion research facility accelerator. The readout electronics are divided into Front-end Card (FEC) and Readout Control Unit (RCU). FEC uses Topmetal II minus…

We present the development of a single-photon detector and the connected read-out electronics. This `hybrid' detector is based on a vacuum tube, transmission photocathode, microchannel plate and a pixelated CMOS read-out anode encapsulating…

A super module assembled with MRPC detectors is a component of TOF (Time of Flight) system for the Compressed Baryonic Matter (CBM) experiment. Before the super modules are applied to CBM-TOF, their quality needs to be evaluated. The…

To cope with the challenging environment of the planned high luminosity upgrade of the Large Hadron Collider (HL-LHC), scheduled to start operation in 2029, CMS will replace its entire tracking system. The requirements for the tracker are…

The conventional readout method of the RPC detector uses two sets of orthogonal readout strips placed at the both sides of the gas gap to collect signals of opposite polarities to obtain space points. A new readout method utilizing the…

The capacitance of the charge collection node of a sensor system is an important parameter for the design of the analog front-end electronics. The analog front-end of high-granularity sensors like for example hybrid pixel detectors need to…

The performace of an ATLAS-A silicon micro-strip detector prototype with FELIX 128 analogue read out chip has been studied. The noise level and the signal to noise ratio have been measured as a funtion of both detector bias and temperature.…

The Resistive Plate Chambers (RPCs) are employed in the CMS experiment at the LHC as dedicated trigger system both in the barrel and in the endcap. This note presents results of the RPC detector uniformity and stability during the 2011 data…