Related papers: A Pixel Detector for Level-1 Triggering at SLHC

The Semiconductor Tracker (SCT) is a silicon strip detector and one of the key precision tracking devices in the Inner Detector of the ATLAS experiment at CERN LHC. The completed SCT has been installed inside the ATLAS experimental cavern…

At the Large Hadron Collider (LHC), the trigger systems for the detectors must be able to process a very large amount of data in a very limited amount of time, so that the nominal collision rate of 40 MHz can be reduced to a data rate that…

Owing to their intrinsic (geometry dependent) radiation hardness, 3D pixel sensors are promising candidates for the innermost tracking layers of the forthcoming experiment upgrades at the Phase 2 High-Luminosity LHC (HL-LHC). To this…

The entire CMS silicon pixel detector will be replaced to operate at the High-Luminosity LHC. In this contribution, the new Tracker Endcap Pixel detector will be presented, focusing on a novel concept to provide both power and data…

The trigger selection capabilities of the ATLAS detector have been significantly enhanced for the LHC Run- 2 in order to cope with the higher event rates and with the large number of simultaneous interactions (pile-up) per protonproton…

For large scale applications, hybrid pixel detectors, in which sensor and read-out IC are separate entities, constitute the state of the art in pixel detector technology to date. They have been developed and start to be used as tracking…

The ALICE High Level Trigger has to process data online, in order to select interesting (sub)events, or to compress data efficiently by modeling techniques.Focusing on the main data source, the Time Projection Chamber (TPC), we present two…

With the planned addition of tracking information to the Compact Muon Solenoid (CMS) Level-1 trigger for the High-Luminosity Large Hadron Collider (HL-LHC), the trigger algorithms can be completely reconceptualized. We explore the…

The upgraded Inner Tracking System (ITS2) of the ALICE experiment at the CERN Large Hadron Collider is based on Monolithic Active Pixel Sensors (MAPS). With a sensitive area of about 10 $m^2$ and 12.5 billion pixels, ITS2 represents the…

The structure of the CMS inner tracking system has been studied using nuclear interactions of hadrons striking its material. Data from proton-proton collisions at a center-of-mass energy of 13 TeV recorded in 2015 at the LHC are used to…

The readout chip for the CMS pixel detector has to deal with an enormous data rate. On-chip zero suppression is inevitable and hit data must be buffered locally during the latency of the first level trigger. Dead-time must be kept at a…

The Large Hadron Collider (LHC) at CERN will undergo major upgrades to increase the instantaneous luminosity up to 5-7.5$\times10^{34}$ cm$^{-2}$s$^{-1}$. This High Luminosity upgrade of the LHC (HL-LHC) will deliver a total of 3000-4000…

A new concept, the Triplet Track Trigger (TTT), is proposed for stand-alone tracking at the first trigger level of the FCC-hh detector. The concept is based on a highly scalable monolithic pixel sensor technology and uses a very simple and…

The pixel detector of CMS can be used to reconstruct very low pT charged particles down to about 0.1 GeV/c. This can be achieved with high efficiency, good resolution and a negligible fake rate for elementary collisions. In the case of…

Mainly due to their outstanding performance the position sensitive silicon detectors are widely used in the tracking systems of High Energy Physics experiments such as the ALICE, ATLAS, CMS and LHCb at LHC, the world's largest particle…

When an X-ray is incident onto the silicon absorber array of a detector, it liberates a large number of electrons, which tend to diffuse outward into what is referred to as the charge cloud. This number can vary from tens to thousands…

For the barrel part of the CMS pixel tracker about 800 silicon pixel detector modules are required. The modules are bump bonded, assembled and tested at the Paul Scherrer Institute. This article describes the experience acquired during the…

Studies of heavy-ion collisions at the LHC will benefit from an array of qualitatively new probes not readily available at lower collision energies. These include fully formed jets at ET > 50 GeV, Z0's and abundantly produced heavy flavors.…

Pixel sensors based on commercial high-voltage CMOS processes are an exciting technology that is considered as an option for the outer layer of the ATLAS inner tracker upgrade at the High Luminosity LHC. Here, charged particles are detected…

The basic principle of operation of silicon sensors with resistive read-out is built-in charge sharing. Resistive Silicon Detectors (RSD, also known as AC-LGAD), exploiting the signals seen on the electrodes surrounding the impact point,…