Related papers: Calibration of CMS calorimeters with LHC proton be…
Physical possibility for bending the LHC protons (or ions) a huge angle of 1-20 degrees in the energy range of 0.45 to 7 TeV by means of a bent channeling crystal of Silicon or Germanium is demonstrated. Such an application can be useful…
Methods are presented for calibrating the hadron calorimeter system of the CMS detector at the LHC. The hadron calorimeters of the CMS experiment are sampling calorimeters of brass and scintillator, and are in the form of one central…
This report overviews studies accomplished in the U70 proton synchrotron of IHEP-Protvino during the recent two decades. Major attention is paid to a routine application of bent crystals for beam extraction from the machine. It has been…
IHEP Protvino has pioneered the wide practical use of bent crystals as optical elements in high-energy beams for beam extraction and deflection on permanent basis since 1989. In the course of IHEP experiments, crystal channeling has been…
The LHC crystal-based collimation system is mainly addressed. A CRYSTAL simulation code for particle tracking in crystals is introduced. Its essence consists in both adequate and fast sampling of proton trajectories in crystals which is…
The CERN Large Hadron Collider (LHC) is designed to collide proton beams of unprecedented energy, in order to extend the frontiers of high-energy particle physics. During the first very successful running period in 2010--2013, the LHC was…
The bent crystals are applied on large accelerators to deflect particle beams in process of extraction and collimation. Recently the proposals of fixed target researches in the LHC are formulated. For realization of this program not only…
Crystal lattice can trap and channel particle beams along major crystallographic directions. In a bent crystal, the channelled particles follow the bend. This makes a basis for an elegant technique of beam steering by means of bent…
The article presents an overview of the results obtained at U-70 accelerator of IHEP to use bent crystals for beam control of high energy protons. Considerable attention is paid to practical application of crystals to create new modes of…
An important experiment for cosmic ray physics is going to be conducted with the colliding proton beams of the CERN LHC. The equivalent energy of the 14 TeV center of mass energy of the colliding proton beams in the LHC is 1017eV in the…
Safe disposal of beam halo is a fundamental requirement of modern superconductive hadron colliders to reduce thermal load on magnets and background to experimental detectors. In the CERN Large Hadron Collider (LHC) a multistage system fully…
The physics motivation, detector design, triggers, calibration, alignment, simulation, and overall performance of the very forward CASTOR calorimeter of the CMS experiment are reviewed. The CASTOR Cherenkov sampling calorimeter is located…
This paper reports on the commissioning and first running experience of the CMS Zero Degree Calorimeters during December 2009. All channels worked correctly. The ZDCs were timed into the data acquisition system using beam splash events.…
The first proof-of-principle experiment on "crystal collimation" was performed with 70-GeV protons on IHEP accelerator. A bent crystal installed in the ring as a primary element upstream of a collimator has reduced the radiation levels…
This paper discusses the design and performance of the time measurement technique and of the synchronization systems of the CMS hadron calorimeter. Time measurement performance results are presented from test beam data taken in the years…
We show that crystal can trap a broad (x, x', y, y', E) distribution of particles and channel it preserved with a high precision. This sampled-and-hold distribution can be steered by a bent crystal for analysis downstream. In simulations…
This study investigates the performance of bent silicon crystals intended to channel hadrons in a fixed-target experiment at the Large Hadron Collider (LHC). The phenomenon of planar channelling in bent crystals enables extremely high…
The resolution and the linearity of time measurements made with the CMS electromagnetic calorimeter are studied with samples of data from test beam electrons, cosmic rays, and beam-produced muons. The resulting time resolution measured by…
This paper describes the experience with the calibration, reconstruction and evaluation of the timing capabilities of the CMS HGCAL prototype in the beam tests in 2018. The calibration procedure includes multiple steps and corrections…
The anticipated performance of calorimeter crystals in the environment expected after the planned High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) at CERN has to be well understood, before informed decisions can be made on the…