Related papers: Flowing Bottomhole Pressure Calculation for a Pump…
We performed an experiment on elementary hydrodynamics. The basic system is a cylindrical bottle from which water flows through a pin-hole located at the bottom of its lateral surface. We measured the speed of the water leaving the…
This article deals with the flow of Newtonian fluids through axially-symmetric corrugated tubes. An analytical method to derive the relation between volumetric flow rate and pressure drop in laminar flow regimes is presented and applied to…
A computationally efficient method to calculate the capillary pressure-saturation relations of immiscible multiphase flow on two-dimensional pore morphologies is presented here. The method is an extension of the Pore Morphology Method that…
The atmospheric plasma is regarded as an effective method for surface treatments because it can reduce the period of process and does not need expensive vacuum apparatus. The performance of non-transferred plasma torches is significantly…
A multiphase flowmeter (MPFM) is used in the upstream oil and gas industry for continuous, in-line, real-time, oil-gas-water flow measurement without fluid separation. An MPFM typically consists of phase-fraction (holdup) and velocity (or…
Numerical algorithm for direct simulation of the gas flow in the Holweck pump is developed. The results illustrating the important features of the flow in the pump are reported. An attention is paid to the problem of the pump design…
The enormous pressure lifting the column of oil in a leaking oil well can thwart efforts to seal the top of the well and prevent oil from rising. When the oil cannot be stopped completely, we propose to slow its flow by filling the well…
We provide a basic method of Smoothed Particle Hydrodynamics (SPH) to simulate liquid droplet with surface tension in three dimensions. Liquid droplet is a simple case for surface tension modeling. Surface tension works only on fluid…
This study developed a simple method to measure liquid surface tension based on curve fitting technique. In this study, the explicit lying droplet profile function in terms of surface tension was derived by solving 2-D Young-Laplace…
Cardiopulmonary resuscitation (CPR) is one of the essential tools to ensure oxygen supply during cardiac arrest. However, the precise effects of chest compression are not quantifiable to this day. This often results in a low quality of…
We construct a thermodynamic model for theoretical calculation of the boiling process of multicomponent mixtures of hydrocarbons (e.g., crude oil). The model governs kinetics of the mixture composition in the course of the distillation…
One dimensional (1D) simulations of the flow and flooding of open channels are known to be inaccurate as the flow is multi-dimensional in nature, especially at the flooded regions. However, multi-dimensional simulations, even in two…
We propose and analyse analogs of optical cavities for atoms using two-well Bose-Hubbard models with pumping and losses. With one well pumped, we find that both the mean-field dynamics and the quantum statistics show a quantitative…
Gas bubbles immersed in a liquid and flowing through a large pressure gradient undergoes volumetric deformation in addition to possible deviatoric deformation. While the high density liquid phase can be assumed to be an incompressible…
Shock tubes simulate blast waves to study their effects in air under laboratory conditions; however, few experimental models exist for simulating underwater blast waves that are needed for facilitating experiments in underwater blast…
A magnetic field rotating on the free surface of a ferrofluid layer is shown to induce considerable fluid motion toward the direction the field is rolling. The measured flow velocity i) increases with the square of the magnetic field…
This paper introduces a novel dynamical pressure boundary condition for weakly-compressible smoothed particle hydrodynamics (WCSPH). Unlike previous methods that rely on indirect approaches or ghost particles, our method integrates the…
Lumped method (Electrical analogy) is a quick and easy way to model human cardiovascular system. In this paper Lumped method is used for simulating a complete model. It describes a 36-vessel model and cardiac system of human body with…
A two-dimensional flow in a 90 degree bent channel is considered. A magnetic field is uniform and parallel to inlet branch of the channel. A spectral/hp element method was used for liquid motion calculations. Three types of steady flows…
In situ thermal transport measurement of flowing fluid could be useful for the characterization and diagnosis of practical thermal systems such as fluid heat exchangers and thermal energy storage systems. Despite abundant reports on the…