Related papers: Patch antennas with new artificial magnetic layers
Theory of a high impedance coil (HIC) - a cable loop antenna with a modified shield - is discussed comprehensively for both in transmitting and receiving regimes. Understanding a weakness of the previously reported HIC in transmitting…
Microstrip patch antennas are low-profile and robust when mounted on rigid surfaces of the devices making them suitable for communication and millimeter-wave applications. In this paper, an antenna is designed for the resonant frequency of…
Fluid antennas (FAs) and movable antennas (MAs) have attracted increasing attention in wireless communications recently. As compared to the conventional fixed-position antennas (FPAs), their geometry can be dynamically reconfigured, such…
Recently, as explosive growth of mobile data traffic, the performance of wireless communication systems requires to be enhanced significantly in future. Intelligent reflecting surface (IRS) can be used as a promising way to improve the…
The proliferation of large multi-antenna configurations operating in high frequency bands has recently challenged the conventional far-field, rich-scattering paradigm of wireless channels. Extra large antenna arrays must usually work in the…
Movable antennas (MAs) and intelligent reflecting surfaces (IRSs) enable active antenna repositioning and passive phase-shift tuning for channel reconfiguration, respectively. Integrating MAs and IRSs boosts spatial degrees of freedom,…
Reconfigurable intelligent surfaces (RISs) are regarded as a promising emerging hardware technology to improve the spectrum and energy efficiency of wireless networks by artificially reconfiguring the propagation environment of…
Far-field shaping of small antennas is a challenge and the realizations of non-dipole radiation of small to intermediate sized antennas are difficult. Here we examine the antenna bandwidth cost associated with such constraints, and in…
Massive MIMO is considered a key technology for 5G. Various studies analyze the impact of the number of antennas, relying on channel properties only and assuming uniform antenna gains in very large arrays. In this paper, we investigate the…
Reconfigurable intelligent surfaces (RISs) have promising coverage and data rate gains for wireless communication systems in 5G and beyond. Prior work has mainly focused on analyzing the performance of these surfaces using computer…
This work studies a low-complexity design for reconfigurable intelligent surface (RIS)-aided multiuser multiple-input multiple-output systems. The base station (BS) applies receive antenna selection to connect a subset of its antennas to…
Single Layer Capacitor-Based Antenna Technology introduces a novel approach to address limitations of traditional antenna designs. It leverages the simplicity and efficiency of single-layer capacitors to achieve: Compactness: Enables…
Intelligent reflecting surface (IRS) is a promising technology for achieving high spectrum efficiency in future wireless networks by leveraging massive low-cost reflecting elements with each reflecting the incident signal with a proper…
Traditional antenna pattern measurements involve minimizing the impact of multipath propagation in the measurement environment. In contrast, this work introduces a measurement approach that uses rather than mitigates multipath propagation.…
This paper presents a multi-bit reconfigurable intelligent surface (RIS) with a high phase resolution, capable of beam-steering in the azimuthal plane at sub-6 Gigahertz (GHz). Field trials in realistic indoor deployments have been carried…
We investigate transmission optimization for intelligent reflecting surface (IRS) assisted multi-antenna systems from the physical-layer security perspective. The design goal is to maximize the system secrecy rate subject to the source…
Surface plasmons with MHz-GHz energies are predicted by using milliparticles made of metamaterials that behave like metals in the radiofrequency range. In this work, the so-called Radioplasmonics is exploited to design scatterers embedded…
The purpose of this paper is to introduce a communication model for Large Intelligent Surfaces (LIS). A LIS is modelled as a collection of tiny closely spaced antenna elements. Due to the proximity of the elements, mutual coupling arises.…
The miniaturisation of optical systems is an ongoing challenge across the electromagnetic spectrum. While the thickness of optical elements themselves can be reduced using advances in metamaterials, it is the voids between these elements --…
Radar cross section (RCS) reduction has become one of the critical research areas in recent years. The RCS of the target should be small to avoid detection. Different methods are used to reduce RCS, but the major challenge with many RCS…