Related papers: A novel approach for the temperature dependency of…
An analytically expression for the temperature dependence of the signal gain of an erbium-doped fiber amplifier (EDFA) pumped at 1480 \textit{nm} are theoretically obtained by solving the propagation equations with the amplified spontaneous…
The dependence of the relative population inversion in Er3+-doped fiber amplifiers (EDFAs) upon temperature and cross sections, taking into account the amplified spontaneous emission (ASE), are investigated theoretically by the modified…
The influence of low temperatures on the performance of a high-power single-frequency fiber laser amplifier is evaluated with a numerical simulation. Cooling the fiber can allow to take advantage of both higher damping of the acoustic waves…
Erbium-doped solids are promising candidates for fiber-based quantum networks due to their emission wavelength, which aligns with the telecom band over which optical fibers exhibit minimal loss. Among these, erbium-doped silica fiber (EDF)…
We use a detailed numerical model of stimulated thermal Rayleigh scattering to compute mode instability thresholds in Tm$^{3+}$-doped fiber amplifiers. The fiber amplifies 2040 nm light using a 790 nm pump. The cross-relaxation process is…
We report design and subsequent fabrication of an intrinsically gain flattened Erbium doped fiber amplifier (EDFA) based on a highly asymmetrical and concentric dual-core fiber, inner core of which was only partially doped. Phase-resonant…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump…
Thermal effects are critical constrains for developing high-power thulium-doped fiber lasers (TDFLs). In this paper, we numerically investigate the lasing and thermal characteristics of the TDFLs under different pump transitions. Our…
We experimentally study a fiber loop laser with an integrated Erbium doped fiber (EDF). The output optical spectrum is measured as a function of the EDF temperature. We find that below a critical temperature of about 10K the measured…
A lot of research is focused on all-optical signal processing, aiming to obtain effective alternatives to existing data transmission platforms. Amplification of light in fiber optics, such as in Erbium-doped fiber amplifiers, is especially…
Fiber-based multi-wavelength lasers have a variety of important applications in telecommunication and meteorology. We experimentally study a fiber loop laser with an integrated Erbium doped fiber (EDF). The output optical spectrum is…
Using a numerical model we study the frequency dependence of mode coupling gain due to stimulated thermal Rayleigh scattering in step index, Yb doped, fiber amplifiers. The frequency at the gain peak is shown to vary with core size, doping…
We propose a simplified rate-equation model for the 1500 nm to 980 nm upconversion in Er$^{3+}$. The simplifications, based on typical experimental conditions as well as on conclusions based on previously published more advanced models,…
A pulsed regime of short-cavity, heavily erbium-doped fiber lasers is of high interest for its possible applications in telecommunications and sensorics. Here, we demonstrate these lasers in two configurations, distributed feedback laser…
Spintronic terahertz emitters (STEs) pumped by femtosecond lasers have become a widely used source of broadband terahertz radiation. However, the strength of the emitted field is limited in part by the optical damage threshold at the pump…
We propose what we believe to be a novel type of optical source for ultra-cold atomic Far Off-Resonance optical-dipole Traps (FORTs). The source is based on an Erbium Amplified Spontaneous Emission (ASE) source that seeds a high power…
The use of short lengths of large core phosphate glass fibre, doped with high concentrations of Er or Er:Yb represents an attractive route to achieving high power erbium doped fibre amplifiers (EDFAs) and lasers (EDFLs). With the aim of…
We report the design and demonstration of novel 2 $\mu$m band Watt-level fiber amplifiers, fiber lasers, and wideband ASE sources that are pumped with broad spectrum Watt-level ASE sources instead of conventional fiber laser pumps. We show…
Multi-longitudinal-mode lasers have been believed to be good candidates as pump sources for optical frequency conversion. However, we present a semi-classical model for frequency conversion of optical signals with a multimode pump laser,…
This is the report on new development of an automated precision load-based measurement setup for thermoelectric power of different types of samples in the temperature range 5 - 330 K. The problems in the old spring-based setup have been…