Related papers: DAFNE injection system upgrade
The energy doubling of the Frascati DAFNE Phi-factory can be accomplished either by ramping the energy of the rings from the initial 510 MeV of the injected beam or by upgrading the present Linac Energy to > 1.02 GeV so to inject the beam…
DAFNE is the electron-positron collider operating at the energy of Phi-resonance, 1 GeV in the center of mass. The presently achieved luminosity is by about two orders of magnitude higher than that obtained at other colliders ever operated…
The Proton Improvement Plan - II (PIP-II) injector linac is an 800 MeV superconducting H$^-$ linac, christened Linac2, that will replace the existing 400 MeV injector to the accelerator complex at Fermilab. The higher energy, intensity and…
Test beam and irradiation facilities are the key enabling infrastructures for research in high energy physics (HEP) and astro-particles. In the last 11 years the Beam-Test Facility (BTF) of the DA{\Phi}NE accelerator complex in the Frascati…
This project proposes to reuse the DAFNE accelerator complex for producing a high intensity (up to 10^10), high-quality beam of high-energy (up to 500 MeV) positrons for HEP experiments, mainly - but not only - motivated by light dark…
The completion of the PIP-II project and its superconducting linear accelerator will provide up to 1.2 MW of beam power to the LBNF/DUNE facility for neutrino physics. It will also be able to produce high-power beams directly from the linac…
DAFNE induced backgrounds are dominated by Touschek scattering [1]. A luminosity upgrade of the machine at the same beam energy would be obtained essentially by increasing the bunch density, that in principle would increase this particle…
The idea of using fixed-target annihilations of a high-energy positron beam on a target for producing a new, very feebly interacting particle has been exploited by the PADME experiment at LNF using the extracted beam from the LINAC in the…
The injector linacs of the JLC/NLC comprise the e+ booster, the e- drive linac, the e+ booster, and the two prelinacs. These four systems together transport the two types of beams from the 80 MeV point at the end of their respective…
In order to dissipate long-lived radioactive waste, not only high ux proton accelerator but also electron linac have been proposed. A proton accelerator directly induces nuclear fission and mutation. On the other hand, electron beam has two…
For the future neutrino oscillation experiment DUNE, liquid argon time projections chambers with a fiducial mass of 10 kton each are foreseen. The dual phase concept is one of the two implementations considered, wherein electrons produced…
A light source based on an Energy Recovered Linac (ERL) [1] consist of a superconducting linac and a transfer line that includes wigglers and undulators to produce the synchrotron light. The transfer line brings the electrons bunches back…
The option to install two injectors is foreseen at the European XFEL Facility. The injectors will be located on top of each other in the same building, both with the offset of 2.75 m with respect to the main linac axis. The translation…
The creation of intense radioactive beams requires intense and energetic primary beams. A task force analysis of this subject recommended an acceleration system capable of 400 MeV/u uranium at 1 particle uA as an appropriate driver for such…
An on-axis injection scheme using a double-frequency RF system in a storage ring with small dynamic aperture is proposed. By altering RF voltages, empty RF buckets can be created which will be used for on-axis injection. After bunches are…
This paper describes the concept of a primary electron beam facility at CERN, to be used for dark gauge force and light dark matter searches. The electron beam is produced in three stages: A Linac accelerates electrons from a photo-cathode…
This document describes the concept of a primary electron beam facility at CERN, to be used for dark gauge force and light dark matter searches. The electron beam is produced in three stages: A Linac accelerates electrons from a…
The FNAL accelerator complex is poised to reach MW neutrino beams on target for the exploration of the dark sector physics and rare physics program spaces. Future operations of the complex will include CW linac operations at beam…
The high-luminosity requirement in future lepton colliders imposes a need for a high-intensity positron source. In the conventional scheme, positron beams are obtained by the conversion of bremsstrahlung photons into electron-positron pairs…
Radio-frequency linear accelerators are used as injectors for synchrotrons and as stand-alone accelerators for the production of intense particle beams, thanks to their ability to accelerate high beam currents at high repetition rates. This…