Related papers: Fabrication-tolerant high quality factor photonic …
We show that, taking a two-dimensional photonic-crystal slab system as an example, surprisingly high quality factors (Q) over 10^5 are achievable, even in the absence of a rigorous photonic-band-gap. We find that the density of in-plane…
Optical microcavities confine light spatially and temporally and find application in a wide range of fundamental and applied studies. In many areas, the microcavity figure of merit is not only determined by photon lifetime (or the…
We report the fully-scalable fabrication of a large array of hybrid molybdenum disulfide (MoS$_2$) - silicon dioxide (SiO$_2$) one-dimensional, free-standing photonic-crystal cavities capable of enhancement of the MoS$_2$ photoluminescence…
A wide variety of applications of microwave cavities, such as measurement and control of superconducting qubits, magnonic resonators, and phase noise filters, would be well served by having a highly tunable microwave resonance. Often this…
One dimensional nanobeam photonic crystal cavities are fabricated in silicon dioxide with silicon nanocrystals. Quality factors of over 9 x 10^3 are found in experiment, matching theoretical predictions, with mode volumes of 1.5(lambda/n)^3…
We demonstrate the fabrication of defect-free optical-nanofiber photonic-crystal Fabry-Perot resonators with quality factors exceeding 10^7 using single-shot femtosecond laser ablation. An investigation of the nonlinear optical properties…
We describe the fabrication and measurement of microwave coplanar waveguide resonators with internal quality factors above 10 million at high microwave powers and over 1 million at low powers, with the best low power results approaching 2…
We propose and analyze a new type of a resonant high-Q cavity for lasing, sensing or filtering applications, which is based on a surface states of a finite photonic crystal. We demonstrate that such the cavity can have a Q factor comparable…
We design high quality factor photonic crystal nanobeam cavities formed by two mechanically isolated cantilevers. These "split-beam" cavities have a physical gap at the center, allowing mechanical excitations of one or both of the cavity…
We report on the design, fabrication and optical characterization of bichromatic photonic crystal cavities in thin silicon membranes, with resonances around 1550 nm wavelength. The cavity designs are based on a recently proposed photonic…
We have measured time-resolved the photon storage time and the quality factor of an ultrafast photonic cavity using an autocorrelator. The cavity consists of a $\lambda$-thick GaAs layer sandwiched between GaAs/AlAs distributed Bragg…
Cavities with high quality (Q) factor and small mode-volume are crucial to realize high performance nanolasers suitable for optical interconnects. In this work, we propose a novel one-dimensional photonic crystal nanobeam cavity design with…
It is usually assumed that when performing a photoluminescence experiment on a microcavity containing an inhomogeneously broadened quantum dots ensemble, the cavity mode appears as a positive peak with a linewidth that reflects the mode…
We demonstrate experimentally an air-slot mode-gap photonic crystal cavity with quality factor of 15,000 and modal volume of 0.02 cubic wavelengths, based on the design of an air-slot in a width-modulated line-defect in a photonic crystal…
We present the first observation of optomechanical coupling in ultra-high Q crystalline whispering-gallery-mode (WGM) resonators. The high purity of the crystalline material enables optical quality factors in excess of 10^{10} and finesse…
We report disk-shaped silicon optomechanical resonators with frequency up to 1.75 GHz in the ultrahigh frequency band. Optical transduction of the thermal motion of the disks' in-plane vibrational modes yields a displacement sensitivity of…
We report on fabrication of on-chip calcium fluoride (CaF2) microdisk resonators using water-assisted femtosecond laser micromachining. Focused ion beam (FIB) milling is used to create ultra-smooth sidewalls. The quality (Q)-factors of the…
The microwave cavity perturbation method is often used to determine material parameters (electric permittivity and magnetic permeability) at high frequencies and it relies on measurement of the resonator parameters. We present a method to…
With a highly coherent, optically addressable electron spin, the nitrogen vacancy (NV) centre in diamond is a promising candidate for a node in a quantum network. However, the NV centre is a poor source of coherent single photons owing to a…
We employ a combined shape- and topology-optimization strategy to design manufacturable two-dimensional photonic crystal-based optical nanocavities that confine light to length scales well below the resonance wavelength. We present details…