Related papers: Construction and Tests of Modules for the ATLAS Pi…
The simulation and analysis of High Energy Physics experiments require a realistic simulation of the detector material and its distribution. The challenge is to describe all active and passive parts of large scale detectors like ATLAS in…
In order to fully exploit the physics potential of a future high energy e+e- linear collider, a Vertex Tracker, providing high resolution track reconstruction, is required. Hybrid Silicon pixel sensors are an attractive option, for the…
During the LHC Long Shutdown 3 (2026-29) ALICE will replace its three innermost tracking layers by a new detector, the "ITS3". It will be based on newly developed, wafer-scale monolithic active pixel sensors, which are bent into truly…
The LHC is expected to reach luminosities up to 3000fb-1 and the innermost layer of the ATLAS upgrade plans to cope with higher occupancy and to decrease the pixel size. 3D-Si sensors are a good candidate for the innermost layer of the…
Charged-particle reconstruction is a fundamental part of the event reconstruction in modern multi-purpose high-energy physics detectors. This paper describes the algorithms used to reconstruct charged particles and primary vertices with the…
The CMS pixel detector is the innermost component of the CMS tracker occupying the region around the centre of CMS, where the LHC beams are crossed, between 4.3 cm and 30 cm in radius and 46.5 cm along the beam axis. It operates in a…
The inner detector is the central tracking device of the ATLAS detector. In these proceedings the tracking performance of the inner detector is presented on collision data recorded at $\sqrt{s}$ = 900 GeV and 7 TeV. The identification of…
The Inner Tracking System (ITS) of the ALICE experiment at CERN will undergo an upgrade during the LHC long shutdown 3, in which the three innermost tracking layers will be replaced. This upgrade, named the Inner Tracking System 3 (ITS3),…
In view of the LHC upgrade for the High Luminosity Phase (HL-LHC), the ATLAS experiment is planning to replace the Inner Detector with an all-Silicon system. The n-on-p technology represents a valid solution for the modules of most of the…
While the tracking detectors of the ATLAS and CMS experiments have shown excellent performance in Run 1 of LHC data taking, and are expected to continue to do so during LHC operation at design luminosity, both experiments will have to…
The ITk is a new silicon tracker for the ATLAS experiment designed to increase detector resolution, readout capacity, and radiation hardness, in preparation for the larger number of simultaneous proton-proton interactions at the High…
DEPFET pixel detectors are unique devices in terms of energy and spatial resolution because very low noise (ENC = 2.2e at room temperature) operation can be obtained by implementing the amplifying transistor in the pixel cell itself. Full…
The performance of the ATLAS Inner Detector alignment has been studied using $pp$ collision data at $\sqrt{s} = 13$ TeV collected by the ATLAS experiment during Run 2 (2015 to 2018) of the Large Hadron Collider (LHC). The goal of the…
Hybrid pixel detectors have been invented for the LHC to make tracking and vertexing possible at all in LHC's radiation intense environment. The LHC pixel detectors have meanwhile very successfully fulfilled their promises and R\&D for the…
In this talk we present the basis for the protocol for radiation monitoring of the ATLAS Pixel Sensors. The monitoring is based on a current measurement system, HVPP4. The status on the ATLAS HVPP4 system development is also presented.
Allpix$^2$ (read: Allpix Squared) is a generic, open-source software framework for the simulation of silicon pixel detectors. Its goal is to ease the implementation of detailed simulations for both single detectors and more complex setups…
The high integration density of MAPS, with silicon sensor and readout electronics implemented in the same device, allows very thin structures with a greatly reduced material budget. Thicknesses of $\mathcal{O}$(50~$\mu$m), values at which…
Monolithic Active Pixel Sensors (MAPS) combine the sensing part and the front-end electronics in the same silicon layer, making use of CMOS technology. Profiting from the progresses of this commercial process, MAPS have been undergoing…
This paper describes the integration structures for the silicon strips tracker of the ATLAS detector proposed for the Phase-II upgrade of the Large Hadron Collider (LHC), also referred to as High Luminosity LHC (HL-LHC). In this proposed…
The ATLAS Forward Proton (AFP) detector is intended to measure protons scattered at small angles from the ATLAS interaction point. To this end, a combination of 3D Silicon pixel tracking modules and Quartz-Cherenkov time-of-flight (ToF)…