Related papers: The DZERO Level 3 Data Acquistion System

We have developed a silicon pixel detector to enhance the physics capabilities of the PHENIX experiment. This detector, consisting of two layers of sensors, will be installed around the beam pipe at the collision point and covers a…

The RHIC interaction rate at sPHENIX will reach around 3 MHz in pp collisions and requires the detector readout to reject events by a factor of over 200 to fit the DAQ bandwidth of 15 kHz. Some critical measurements, such as heavy flavor…

At the end of its operations in 2011, the Fermilab antiproton production complex consisted of a sophisticated target system, three 8-GeV storage rings (namely the Debuncher, the Accumulator and the Recycler), 25 independent multi-GHz…

In LHC Run 3, the upgraded ALICE detector will record Pb-Pb collisions at a rate of 50 kHz usingcontinuous readout. The resulting stream of raw data at 3.5 TB/s has to be processed with a setof lossy and lossless compression and data…

RZBENCH is a benchmark suite that was specifically developed to reflect the requirements of scientific supercomputer users at the University of Erlangen-Nuremberg (FAU). It comprises a number of application and low-level codes under a…

The Real-Time Systems Engineering Department of the Scientific Computing Division at Fermilab has deployed set of customizations to our Off-The-Shelf Data Acquisition solution (otsdaq) at the Fermilab Test Beam Facility (FTBF) to read out…

The upgraded LHCb detector has started its Run 3 of data taking in 2022, with a completely overhauled DAQ system, reading out and processing the full detector data at every LHC bunch crossing (30 MHz average rate). At the same time, an…

With the increasing physical event rate and number of electronic channels, traditional readout scheme meets the challenge of improving readout speed caused by the limited bandwidth of crate backplane. In this paper, a high-speed data…

The D0 experiment at Fermilab's Tevatron will record several petabytes of data over the next five years in pursuing the goals of understanding nature and searching for the origin of mass. Computing resources required to analyze these data…

The JEM-EUSO program aims at detecting Ultra High Energy Cosmic Rays (UHECRs) by observing the fluorescence light produced by extensive air showers (EAS) in the Earth's atmosphere. Within this program, a new generation of missions is being…

The NA62 experiment at CERN SPS started physics data taking this year with the aim to measure the ultra-rare decay $K^+\to\pi^+\nu\bar{\nu}$. The experiment consists of a large number of subsystems to reach the goal of 10% accuracy and less…

Current, state-of-the-art CCDs are close to being able to deliver all key performance figures for future strategic X-ray missions except for the required frame rates. Our Stanford group is seeking to close this technology gap through a…

An effort is underway to develop streaming readout data acquisition system for the CLAS12 detector in Jefferson Lab's experimental Hall-B. Successful beam tests were performed in the spring and summer of 2020 using a 10GeV electron beam…

For the final running period of HERA, a recoil detector was installed at the HERMES experiment to improve measurements of hard exclusive processes in charged-lepton nucleon scattering. Here, deeply virtual Compton scattering is of…

The CYGNO experiment employs an optical readout to image particle interactions in a gaseous Time Projection Chamber (TPC), combining cameras and photomultiplier tubes (PMTs) to achieve high spatial resolution and timing information. This…

A longitudinal beam properties, data acquisition system has been commissioned to operate in the Fermilab booster ring. This system captures real time information including beam synchronous phase, bunch length, and coupled bunch instability…

The LZ program consists of two stages of direct dark matter searches using liquid Xe detectors. The first stage will be a 1.5-3 tonne detector, while the last stage will be a 20 tonne detector. Both devices will benefit tremendously from…

Large area LaBr3:Ce detectors with a SiPM array readout have been developed for the FAMU experiment at RAL. The aim was to have a good energy resolution for low energy X-rays detection (around 100 keV) and good timing properties of the…

In planning for the Phase II upgrades of CMS and ATLAS major considerations are: 1)being able to deal with degradation of tracking and calorimetry up to the radiation doses to be expected with an integrated luminosity of 3000 $fb^{-1}$ and…

Optical readout of large Time Projection Chambers (TPCs) with multiple Gas Electron Multipliers (GEMs) amplification stages has shown to provide very interesting performances for high energy particle tracking. Proposed applications for…