Related papers: YBCO Transition Edge Sensors Used For Very Low Noi…
We present the electro-thermal characterization of transition-edge sensor (TES) detectors suspended on Si membranes fabricated using a silicon-on-insulator (SOI) wafer. The use of an all-silicon fabrication platform, in contrast to the more…
The Simons Observatory aims to field 70,000 Transition-Edge Sensor (TES) bolometers to measure the Cosmic Microwave Background. With so many detectors, rapid but accurate validation of their properties prior to their integration into…
In this letter, we present the performance of a $100~\mu\mathrm{m}\times 400~\mu\mathrm{m} \times 40~\mathrm{nm}$ tungsten (W) Transition-Edge Sensor (TES) with a critical temperature of 40 mK. This device has a measured noise equivalent…
We report on the temperature-dependent optical response of thin films of YBa2Cu3O7-{\delta} (YBCO) in the visible spectral range under cryogenic conditions. Specifically, we observe an increase in transmittance near the superconducting…
Superconducting transition temperatures Tc of the YBCO film surface and of the YBCO film/substrate interface were measured inductively. It was observed that the interface- Tc is always higher then the surface - Tc. However deposition of…
High-temperature superconducting YBa2Cu3O7-d (YBCO) thin-film detectors with improved responsivities were developed for fast time-domain measurements in the THz frequency range. YBCO thin films of 30 nm thickness were patterned to micro-…
Electroplated Bismuth (Bi) is commonly used in Transition-Edge Sensors (TESs) for X-rays because of its high stopping power and low heat capacity. Electroplated Bi is usually grown on top of another metal that acts as seed layer, typically…
A light-beam-assisted temperature-control system operating within a temperature range from 77 to 180 K is developed for investigating the absorption of electromagnetic waves by high-temperature superconductors in the vicinity of…
We propose to operate a superconducting transition edge sensor (TES) using a different type of biasing, in which the resistance of the TES is kept constant by means of feedback on the bias voltage and is independent of the incoming signal…
Transition-edge sensors (TES) as microcalorimeters for high-energy-resolution X-ray spectroscopy are often fabricated with an absorber made of materials with high Z (for X-ray stopping power) and low heat capacity (for high resolving…
Kinetic inductance detectors (KIDs) show promise as a competitive technology for astronomical observations over a wide range of wavelengths. We are interested in comparing the fundamental limitations to the sensitivity of KIDs with that of…
Current-voltage characteristics of Au~/~YBa$_2$Cu$_3$O$_{7-\delta}$ interfaces (Au/YBCO), built on optimally-doped YBCO thin films, grown by pulsed laser deposition, were measured as a function of temperature in the 50 K to 270 K range, for…
We study the mechanism of instability in transition edge sensor (TES) bolometers used for ground based observations of the Cosmic Microwave Background (CMB) at 270GHz. The instability limits the range of useful operating resistances of the…
We have developed two analytical models to describe the performance of cryogenic microcalorimeters and bolometers. One of the models is suitable to describe Transition Edge Sensor (TES) detectors with an integrated absorber, the other is…
The thermometer and thermal control system, for the Absolute Radiometer for Cosmology, Astrophysics, and Diffuse Emission (ARCADE) experiment, is described, including the design, testing, and results from the first flight of ARCADE. The…
We have studied the physics of transition-edge sensor (TES) devices with an insulating AlOx layer on top of the device to allow implementation of more complex detector geometries. By comparing devices with and without the insulating film,…
Transition-edge sensors (TESs) are capable of highly accurate single particle energy measurement. TESs have been used for a wide range of photon detection applications, particularly in astronomy, but very little consideration has been given…
We present a study of the energy resolution of transition-edge sensors (TESs) for the detection of electrons in the 100 eV kinetic energy range. The TES is a Ti-Au bilayer with an active area of $(60 \times 60)$ $\mu \text{m}^2$ and a…
We report results regarding the electron transport in vertical quasi-2D layered 1T-TaS2 charge-density-wave devices. The low-frequency noise spectroscopy was used as a tool to study changes in the cross-plane electrical characteristics of…
Transition-Edge Sensors (TESs) are two-dimensional superconducting films used to detect energy or power. TESs are voltage biased in the resistive transition where the film resistance is both finite and a strong function of temperature.…