Related papers: Method for control gas diffusion and bubbles forma…
We demonstrate and explain a simple and efficient way to remove gas bubbles from liquid-filled microchannels, by integrating a hydrophobic porous membrane on top of the microchannel. A prototype chip is manufactured in hard, transparent…
In a microfluidic environment, the presence of bubbles is often detrimental to the functionality of the device, leading to clogging or cavitation, but microbubbles can also be an indispensable asset in other applications such as…
Past work has shown that ions can pass through a membrane more readily in one direction than the other. We demonstrate here in a model and an experiment that for a mixture of small and large particles such asymmetric diffusion can arise…
We consider a liquid bearing gas bubbles in a porous medium. When gas bubbles are immovably trapped in a porous matrix by surface-tension forces, the dominant mechanism of transfer of gas mass becomes the diffusion of gas molecules through…
We show that during evaporation of a pore network, liquid can refill the gas occupied pores, snapping off a gas bubble, which then moves to a stable configuration. This phenomenon is induced by the capillary instability due to the…
We have designed and constructed an experimental system to study gas bubble growth in slightly supersatu- rated liquids. This is achieved by working with carbon dioxide dissolved in water, pressurized at a maximum of 1 MPa and applying a…
A microscopic bubble of soluble gas always dissolves in finite time in an under-saturated fluid. This diffusive process is driven by the difference between the gas concentration near the bubble, whose value is governed by the internal…
An increasing number of research topics and applications ask for a precise measurement of the size distribution of small bubbles in a liquid - and hence for reliable and automated image analysis. However, due to the strong mismatch between…
In this paper, the size of bubbles formed through the breakup of a gaseous jet in a co-axial microfluidic device is derived. The gaseous jet surrounded by a co-flowing liquid stream breaks up into monodisperse microbubbles and the size of…
The collapse of a gas or vapour bubble near a non-porous boundary is directed at the boundary due to the asymmetry induced by the nearby boundary. High surface pressure and shear stress from this collapse can damage, or clean, the surface.…
Bubbles and droplets are ubiquitous in many areas of engineering, including microfluidics where they can serve as microreactors for screening of chemical reactions. They are often formed out of a constriction (a microfluidic channel or a…
The problem of the diffusion evolution of a pore filled with molecular hydrogen in a spherical granule in a hydrogen medium is solved. The initial position of the pore is displaced relative to the center of the granule. A nonlinear system…
We present a novel microfluidic method to produce quasi-monodisperse bubbles with diameters from tens to very few microns. A gaseous rivulet flows over the shallow groove printed on a T-junction exit channel. The triple contact line…
We measure the liquid content, the bubble speeds, and the distribution of bubble sizes, in a vertical column of aqueous foam maintained in steady-state by continuous bubbling of gas into a surfactant solution. Nearly round bubbles…
Gas bubble growth as a result of diffusion flux of dissolved gas molecules from the surrounding supersaturated solution to the bubble surface is studied. The condition of the flux steadiness is revealed. A limitation from below on the…
We show that phase separation can occur in a one-component liquid outside its coexistence curve (CX) with addition of a small amount of a solute. The solute concentration at the transition decreases with increasing the difference of the…
To further understand their nature, micro cavitation bubbles were systematically diffused around the exterior of a test body (tube) fully submerged in a water tank. The primary purpose was to assess the feasibility of applying micro…
The process of bubble formation from an orifice submerged in liquid with constant gas flow is studied by numerical simulations using an OpenFOAM volume-of-fluid solver named interIsoFoam. The computed results show that the detached bubble…
Drag reduction by microbubbles is a promising engineering method for improving ship performance. A fundamental theory of the phenomenon is lacking however, making actual design quite uphazard. We offer here a theory of drag reduction by…
Aqueous foams coarsen with time due to gas diffusion through the liquid. The mean bubble size grows, and small bubbles vanish. However, coarsening is little understood for foams with an intermediate liquid content, particularly in the…