Related papers: Fast Electronics for the Dafne Transverse Feedback…
From 2004 the Frascati Beam Test Facility (BTF) in the DAFNE accelerator complex provides to the external user up to 1E10 electrons per bunch or up to 10E9 positrons per bunch to develop their detectors. After an upgrade program terminated…
The complexity of applications addressed with photonic integrated circuits is steadily rising and poses increasingly challenging demands on individual component functionality, performance and footprint. Inverse design methods have recently…
We report a mixed-signal data acquisition (DAQ) system for optically detected magnetic resonance (ODMR) of solid-state spins. This system is designed and implemented based on a Field-Programmable-Gate-Array (FPGA) chip assisted with…
This paper considers an affine frequency division multiplexing (AFDM)-based integrated sensing and communications (ISAC) system, where the AFDM waveform is used to simultaneously carry communications information and sense targets. To…
Accurate real-time assessment of power systems voltage stability has been an active area of research in the past few decades. In the past decade, after the development of phasor measurement units (PMU), a lot of discussions has been going…
Model-based feedforward control improves tracking performance of motion systems, provided that the model describing the inverse dynamics is of sufficient accuracy. Model sets, such as neural networks (NNs) and physics-guided neural networks…
It is difficult to completely eliminate disorder during the fabrication of graphene-based nanodevices. From a simulation perspective, it is straightforward to determine the electronic transport properties of disordered devices if complete…
Conventional boost converters are essential to connect low-voltage energy source such as battery with high voltage DC bus in Electric Vehicles due to its simple construction and high conversion efficiency. However, large output capacitor…
In recent years, high speed and high resolution analog-to-digital converter (ADC) is widely employed in many physical experiments, especially in high precision time and charge measurement. The rapid increasing amount of digitized data…
Nonlinear processes in the quantum regime are essential for many applications, such as quantum-limited amplification, measurement and control of quantum systems. In particular, the field of quantum error correction relies heavily on…
In high energy physics experiments (HEP), high speed and fault resilient data communication is needed between detectors/sensors and the host PC. Transient faults can occur in the communication hardware due to various external effects like…
Phosphorene, a two-dimensional (2D) analog of black phosphorous, has been a subject of immense interest recently, due to its high carrier mobilities and a tunable bandgap. So far, tunability has been predicted to be obtained with very high…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
The reliance on distributed renewable energy has increased recently. As a result, power electronic-based distributed generators replaced synchronous generators which led to a change in the dynamic characteristics of the microgrid. Most…
Digital control has become increasingly widespread in modern power electronic converters. When acquiring feedback signals such as the inductor current, synchronizing the analog-to-digital converter (ADC) with the digital pulse-width…
Atom interferometers offer excellent sensitivity to gravitational and inertial signals but have limited dynamic range. We introduce a scheme that improves on this trade-off by a factor of 50 using composite fringes, obtained from sets of…
Two ways of designing low-order discrete-time (i.e. digital) controls for low-order plant (i.e. process) models are considered in this tutorial. The first polynomial method finds the controller coefficients that place the poles of the…
Parameter variations within the resonant network of wireless power transfer (WPT) systems can cause drift in the resonant frequency, leading to a detuned system that requires higher power capacity and experiences reduced transfer…
Despite the intensive recent research on wireless single-channel full-duplex communications, relatively little is known about the transceiver chain nonidealities of full-duplex devices. In this paper, the effect of nonlinear distortion…
Off-resonant optical imaging is the most popular method for continuous monitoring of a Bose-Einstein condensate (BEC). However, the disturbance caused by scattered photons places a serious limitation on the lifetime of such…