Related papers: Simulation Studies of the NLC with Improved Ground…
Extensive beam-based feedback systems are planned as an integral part of the Next Linear Collider (NLC) control system. Wakefield effects are a significant influence on the feedback design, imposing both architectural and algorithmic…
The design luminosity for the future linear colliders is very demanding and challenging. Beam-based feedback systems will be required to achieve the necessary beam-beam stability and steer the two beams into collision. In particular we have…
The proposed Next Linear Collider (NLC) contains linac systems operating at L,S,C, and X band. This paper describes a wideband modular low-level RF (LLRF) system applicable for all NLC pulsed RF systems. High speed digital IF techniques are…
Ground motion and vibration can be a limiting factor in the performance of future linear colliders. Investigations of ground motion have been carried out around the world for several decades. In this review, results of recent investigations…
The proposed Next Linear Collider contains a large number of linac RF systems with new requirements for wideband klystron modulation and accurate RF vector detection. The system will be capable of automatically phasing each klystron and…
Feedback systems are essential for stable operation of a linear collider, providing a cost-effective method for relaxing tight tolerances. In the Stanford Linear Collider (SLC), feedback controls beam parameters such as trajectory, energy,…
In future normal-conducting linear colliders, the beams will be delivered in short bursts with a length of the order of 100 ns. The pulses will be separated by several ms. In order to maintain high luminosity, feedback is necessary on a…
We present a new conceptual and optical design for the Next Linear Collider post-linac collimation system. Energy collimation and passive protection against off-energy beams are achieved in a system with large horizontal dispersion and…
In the NLC (Next Linear Collider) small misalignments in each of the individual accelerator structures (or the accelerator cells) will give rise to wakefields which kick the beam from its electrical axis. This wakefield can cause BBU (Beam…
A full simulation program based on GEANT4 has been developed to study beam-induced backgrounds in the JLC beam delivery system. We report some results obtained using this program.
The Stanford Linear Collider (SLC) was the first prototype of a new type of accelerator, the electron-positron linear collider. Many years of dedicated effort were required to understand the physics of this new technology and to develop the…
We study the dynamics and the optimization of the shock deceleration supported by a payload when its airborne carrier impacts the ground. We build a nonlinear elastic model for a container prototype and an elastic suspension system for the…
The vibration stability requirements for the Next Linear Collider (NLC) are far more stringent than for the previous generation of Colliders. To meet these goals, it is imperative that the effects of vibration on NLC Linac components from…
During the initial phase of operation, the linacs of the Next Linear Collider (NLC) will contain roughly 5000 X-Band accelerator structures that will accelerate beams of electrons and positrons to 250 GeV. These structures will nominally…
An electron/positron linear collider with a center-of-mass energy between 0.5 and 1 TeV would be an important complement to the physics program of the LHC in the next decade. The Next Linear Collider (NLC) is being designed by a US…
Some possible tests of physics beyond the Standard Model in the next generation collider experiments are considered. The main emphasis is put on the processes which may be studied in the non-conventional $e^-e^-$, $e^-\gamma$ and…
We present a ground motion model for the SLAC site. This model is based on recent ground motion studies performed at SLAC as well as on historical data. The model includes wave-like, diffusive and systematic types of motion. An attempt is…
A conceptual program to use NLC beams for test beams and fixed target physics is described. Primary undisrupted polarized beams would be the most simple to use, but for NLC, the disrupted beams are of good enough quality that they could…
The two main functions of the NLC extraction line include: 1) transmission of the outgoing disrupted beam and secondary particles to the dump with minimal losses; and 2) beam diagnostics and control. In this report, we describe the…
A high-resolution, intratrain position feedback system has been developed to achieve and maintain collisions at the proposed future electron-positron International Linear Collider (ILC). A prototype has been commissioned and tested with a…