Related papers: A Highly Flexible Bunch Compressor for the APS LEU…

Adiabatic soliton spectral compression in a dispersion-increasing fiber is demonstrated both numerically and experimentally. We show a positively-chirped pulse provides better spectral compression in a dispersion-increasing fiber with large…

A three-cell 1.3 GHz, Normal Conducting (NC) buncher is designed for a possible future upgrade of the European XFEL to operate in a continuous-wave (CW) / long pulse (LP) mode. The RF geometry of the buncher is optimized for high shunt…

We describe use of the Advanced Photon Source (APS) rf thermionic gun, alpha magnet beamline, and linac to produce a stable high-brightness beam in excess of 100 amperes peak current with normalized emittance of 10 pi mm-mrad. To obtain…

Currently, Fermilab Booster accelerates ~4.5E12 protons per pulse (ppp) in 81 bunches from 400 MeV to 8 GeV at 15 Hz to provide beam to multiple HEP experiments and is being upgraded to handle higher beam intensity >6.7E12 ppp at a…

We report on the successful experimental generation of electron bunches with ramped current profiles. The technique relies on impressing nonlinear correlations in the longitudinal phase space using a superconducing radiofrequency linear…

The parameters for a 30 GeV test beam are outlined for use with an undulator in the FFTB tunnel where the LCLS will eventually be housed. It is proposed to use the SLAC linac and damping rings in their present mode of operation for PEP II…

An S-band linear accelerator is the source of particles and the front end of the Advanced Photon Source injector. In addition, it supports a low-energy undulator test line (LEUTL) and drives a free-electron laser (FEL). A…

High brightness linear accelerators typically produce electron beams with peaks in the head and/or tail of the current profile. These current horns are formed after bunch compression due to non-linear correlations in the longitudinal phase…

Following successful experience at the BNL AGS, FNAL Tevatron, and CERN SPS, an AC Dipole will be adopted at the LHC for rapid measurements of ring optics. This paper describes some of the parameters of the AC dipole for the LHC, scaling…

A buncher cavity has been developed for the muons accelerated by a radio-frequency quadrupole linac (RFQ). The buncher cavity is designed for $\beta=v/c=0.04$ at an operational frequency of 324 MHz. It employs a double-gap structure…

The Rapid Cycling Synchrotron (RCS) in Chinese Spallation Neutron Source (CSNS) accelerates proton beam from 80Mev to 1.6GeV at a repetition rate of 25Hz. All dipole magnets of RCS are operated at AC with biased DC. Aiming at the properties…

KEK-ATF is doing R&D establishing high-current and low-emittance electron beam for the future linear colliders. In ATF, 15 ps length electron beam is generated by combination of a thermionic gun, a couple of 357 MHz SHBs, and a S-band TW…

Modern accelerator front ends almost exclusively include radio-frequency quadrupoles for initial capture and focusing of the low-energy beam. Dynamics in the RFQ define the longitudinal bunch parameters. Simulation of the SNS RFQ with…

We present a detailed study of the six-dimensional phase space of the electron beam produced by the Cornell Energy Recovery Linac Photoinjector, a high-brightness, high repetition rate (1.3 GHz) DC photoemission source designed to drive a…

The UED (ultrafast electron diffraction) beamline of the KAERI's (the Korea Atomic Energy Research Institute's) WCI (World Class Institute) Center has been successfully commissioned. We have measured the beam emittance by using the…

Recent laser angle-resolved photoemission spectroscopy studies have established the presence of a new kink in the low-energy nodal dispersion of Bi$_2$Sr$_2$CaCu$_2$O$+{8+\delta}$ (Bi-2212). The energy scale (~8-15 meV) of this kink appears…

The vertical plane transverse emittance of accelerated electron bunches at the AWAKE experiment at CERN has been determined, using three different methods of data analysis. This is a proof-of-principle measurement using the existing AWAKE…

The high peak current required in free-electron lasers (FELs) is realized by longitudinal compression of the electron bunches to sub-picosecond length. In this paper, a frequency-domain diagnostic method is described that is capable of…

Attosecond electron beams are essential for investigating ultrafast structural and electronic dynamics in matter with atomic-scale resolution. We propose a novel method that enables robust attosecond-level electron bunch compression. This…

This paper describes a scheme for pump-probe experiments that can be performed at LCLS and at the European XFEL and determines what additional hardware development will be required to bring these experiments to fruition. It is proposed to…