Related papers: Lattice Matching with a Quadrupole Missing

The hybrid multi-bend achromat (HMBA) lattice concept is adopted in some diffraction-limited storage ring designs, which can permit relatively large on-momentum dynamic aperture and relatively weak sextupoles. In a typical HMBA lattice, the…

The Fermilab Linac delivers a variable intensity, 400-MeV beam to the The MuCool Test Area experimental hall via a beam line specifically designed to facilitate measurements of the Linac beam emittance and properties. A 10 m,…

The Future Circular Collider (FCC) study investigates the feasibility of circular colliders in the post-LHC era. The sub-study FCC-ee is a 100 km electron positron collider in the energy range of 90-365 GeV. In order to achieve a design…

Matched beam loading in laser wakefield acceleration (LWFA), characterizing the state of flattening of the acceleration electric field along the bunch, leads to the minimization of energy spread at high bunch charges. Here, we demonstrate…

The effects on beam dynamics from long-range and short-range wakefields from TESLA-type cavities are considered in regard to a proposed FEL oscillator (FE-LO) operating at 120 nm. This would be driven by the Fermilab Accelerator Science and…

A linear electron-positron collider operating at TeV scale energies will provide high precision measurements and allow, for example, precision studies of the Higgs boson as well as searches for physics beyond the standard model. A future…

Important efforts have recently been dedicated to the characterisation and improvement of the design of the post-linac collimation system of the Compact Linear Collider (CLIC). This system consists of two sections: one dedicated to the…

One of the main challenges of the lattice design of synchrotrons, used as light sources or damping rings (DRs), is the minimization of the emittance. The optimal lattice configurations for achieving the absolute minimum emittance are the…

A design study of the diagnostics of a high brightness linac, based on X-band structures, and a plasma accelerator stage, has been delivered in the framework of the EuPRAXIA@SPARC_LAB project. In this paper, we present a conceptual design…

LINAC 4 is a normal conducting H- structure proposed to intensify the proton flux currently available for the CERN accelerator chain. This linac is designed to accelerate a 65 mA beam up to 160 MeV to be injected into the CERN Proton…

During the initial phase of operation, the linacs of the Next Linear Collider (NLC) will contain roughly 5000 X-Band accelerator structures that will accelerate beams of electrons and positrons to 250 GeV. These structures will nominally…

Main parameters of different colliders which can be realized if a special 1 TeV energy linear electron accelerator or corresponding linear collider is constructed tangential to LHC are estimated. It is shown that L_ep=10^32cm^-2s^-1 at…

The LHeC provides an intense, high energy electron beam to collide with the LHC. It represents the highest energy application of energy recovery linac (ERL) technology which is increasingly recognized as one of the major pilot technologies…

The front end of Los Alamos Neutron Science Center (LANSCE) linear accelerator uses four 201.25-MHz Drift-Tube Linacs (DTLs) to accelerate the H+ and H- beams to 100 MeV. Three of the 201.25-MHz DTLs are powered by diacrodes and the first…

The generation of the ultra-bright beams required by modern accelerators and drivers of free-electron lasers (FELs) has generally relied on chicane-based bunch compressions that often result in the microbunching instability. Following…

In order to study the dynamic response of the material and the physical mechanism of the fluid dynamics, an accelerator scenario which can be applied to hard X-ray free electron laser and high energy electron radiography was proposed. This…

Acceleration of polarized electron~(positron) beams in a booster synchrotron may suffer from depolarization due to crossings of many spin depolarization resonances, which could limit its applications. We have studied the spin depolarization…

The use of existing linacs, and in particular light source injectors, for free-electron laser (FEL) experiments is becoming more common due to the desire to test FELs at ever shorter wavelengths. The high-brightness, high-current beams…

The International Linear Collider Technical Design Report (TDR) describes in four volumes the physics case and the design of a 500 GeV centre-of-mass energy linear electron-positron collider based on superconducting radio-frequency…

Phase space matching between two plasma-accelerator (PA) stages and between a PA and a traditional accelerator component is a critical issue for emittance preservation of beams accelerated by PAs. The drastic differences of the transverse…