Related papers: Design and Simulation of a High Frequency High Pow…
This paper presents the design and analysis of a superdirective rectenna optimized for enhanced RF-to-DC efficiency and realised gain, featuring direct impedance matching between the antenna and the rectifier. Employing passively loaded,…
We propose two kinds of wire configurations fabricated on an atom chip surface for creating two-dimensional (2D) adiabatic rf guide with an inhomogeneous rf magnetic field and a homogenous dc magnetic field. The guiding state can be…
Multi-wavelength digital holography enables surface-shape measurements with an exceptional dynamic range by combining interferometric resolution with synthetic wavelengths spanning multiple length scales. Although the concept promises…
We demonstrate theoretically that in a spintronic diode (SD), having a free magnetic layer with perpendicular magnetic anisotropy of the first and second order and no external bias magnetic field, the out-of-plane regime of magnetization…
We present and compare two high-pressure, high-frequency electric-discharge sources for the generation of supersonic beams of fluorine radicals. The sources are based on dielectric-barrier-discharge (DBD) and plate-discharge units attached…
Dielectric barrier discharge (DBD) plasma actuator arrays have been suggested as active flow control devices due to the robust electrohydrodynamic (EHD) force generation in variable atmospheric conditions. DBD plasma augmentation schemes…
We consider the theoretical maximum extractable average power from an energy harvesting device attached to a vibrating table which provides a unidirectional displacement $A\sin(\omega t)$. The total mass of moving components in the device…
We report on an experimental demonstration of laser wakefield electron acceleration using a sub-TW power laser by tightly focusing 30-fs laser pulses with only 8 mJ pulse energy on a 100 \mu m scale gas target. The experiments are carried…
We theoretically study a vibrating pair of parallel electrodes bridged by a (deformed) liquid droplet, which is a recently developed microfluidic device to harvest vibrational energy. The device can operate with various liquids, including…
The absorption of electromagnetic radiation by a planar structure, consisting of a three-layer dielectric-metal-dielectric coating on a metal back-reflector is analysed. The conditions for total absorption are derived. Our analysis shows…
In this paper, the theoretical sustainable capacity of wireless networks with radio frequency (RF) energy harvesting is analytically studied. Specifically, we consider a large scale wireless network where base stations (BSs) and low power…
We report on the fabrication and room temperature measurements of a high frequency electrical signal detector. The device is based on the ballistic transport in graphene to detect a high frequency signal. The observed response is linear in…
We present results of an experiment where, using a 200 GW CO2 laser seed, a 65 MeV electron beam was decelerated down to 35 MeV in a 54 cm long strongly tapered helical magnetic undulator, extracting over 30$\%$ of the initial electron beam…
The radio-frequency (RF) voltage amplification property of a tunnel magnetoresistance device driven by an RF external-magnetic-field-induced ferromagnetic resonance was studied. The proposed device consists of a magnetic tunnel junction…
Thermophotovoltaic systems in principle enable utilization of heat that is usually regarded as wasted energy. However, the wavelength selectivity of the thermal emitter required for high efficiencies is rather difficult to control with…
Harnessing energy from ubiquitous water resources via molecular-scale mechanisms remains a critical frontier in sustainable energy research. Herein, we present a novel evaporation-driven power generator based on a dynamic diode architecture…
The advance in RF energy transfer and harvesting technique over the past decade has enabled wireless energy replenishment for electronic devices, which is deemed as a promising alternative to address the energy bottleneck of conventional…
This paper presents a design and implementation of a high-power Gallium Nitride (GaN)-based multilevel Hbridge inverter to excite wireless charging coils for the wireless power transfer of electric vehicles (EVs). Compared to the…
We report a two-stage, heterodyne rf-to-microwave transducer that combines a tunable electrostatic pre-amplifier with a superconducting electromechanical cavity. A metalized Si$_3$N$_4$ membrane (3 MHz frequency) forms the movable plate of…
Radio frequency wireless power transfer (WPT) enables charging low-power mobile devices without relying on wired infrastructure. Current existing WPT systems are typically designed assuming far-field propagation, where the radiated energy…