Related papers: Pattern selection of cracks in directionally dryin…
We investigate the geometry of two-dimensional polygonal cracking that forms on the air-exposed surface of dried starch slurries. Two different kinds of starches, made from potato and corn, exhibited distinguished crack evolution, and there…
We propose a mathematical model to describe the athermal fluctuations of thin sheets driven by the type of random driving that might be experienced prior to weak crumpling. The model is obtained by merging the F\"oppl-von K\'arm\'an…
In this paper we first obtain the order of stress singularity for a dynamically propagating self-affine fractal crack. We then show that there is always an upper bound to roughness, i.e. a propagating fractal crack reaches a terminal…
Crack advance from short or long pre-cracks is predicted by the progressive failure of a cohesive zone in a strain gradient, elasto-plastic solid. The presence of strain gradients leads to the existence of an elastic zone at the tip of a…
Dynamic fracture in a wide class of materials reveals "fracture energy" $\Gamma$ much larger than the expected nominal surface energy due to the formation of two fresh surfaces. Moreover, the fracture energy depends on the crack velocity,…
In this paper we propose an extension of the model of Liu, Coppersmith et al., in order to allow for arch formation. This extended model qualitatively captures interesting properties of granular materials due to fluctuations of stress…
In this paper the problem of a plane strain hydraulic fracture in elasto-plastic material is analyzed. The analysis is based on Finite Element Method computations of crack propagation and closure to simulate the Mini-Frac calibration test.…
The breakup of glass and alumina plates due to planar impacts on one of their lateral sides is studied. Particular attention is given to investigating the spatial location of the cracks within the plates. Analysis based on a…
We present an experimental micro-model of drying porous media, based on microfluidic cells made of arrays of pillars on a regular grid, and complement these experiments with a matching two-dimensional pore-network model of drying. Disorder,…
We investigate crack propagation in a simple two-dimensional visco-elastic model and find a scaling regime in the relation between the propagation velocity and energy release rate or fracture energy, together with lower and upper bounds of…
In the context of elastic wave propagation in damaged solids, an analytical approach for scattering of antiplane waves by two-dimensional periodic arrays of cracks is developed. Before considering the study of arrays of cracks, the…
Fractal patterns are observed in computational mechanics of elastic-plastic transitions in two models of linear elastic/perfectly-plastic random heterogeneous materials: (1) a composite made of locally isotropic grains with weak random…
Aligned finger structures, with a characteristic width, emerges during the slow drainage of a liquid/granular mixture in a tilted Hele-Shaw cell. A transition from vertical to horizontal alignment of the finger structures is observed as the…
Fractures are a critical process in how materials wear, weaken, and fail whose unpredictable behavior can have dire consequences. While the behavior of smooth cracks in ideal materials is well understood, it is assumed that for real,…
While we fundamentally understand the dynamics of 'simple' cracks propagating in brittle solids within perfect (homogeneous) materials, we do not understand how paths of moving cracks are determined. We experimentally study strongly…
Due to their microstructure, quasi brittle materials present rough cracks. Under sliding of the crack lips, this roughness involves in one hand induced opening and in the other hand some apparent plasticity which is due to the interlocking…
It is shown here that fracture after a brief plastic strain, typically of a few percents, is a necessary consequence of the polycrystalline nature of the materials. The polycrystal undergoing plastic deformation is modeled as a flowing…
When a frictional interface is subject to a localized shear load, it is often (experimentally) observed that local slip events initiate at the stress concentration and propagate over parts of the interface by arresting naturally before…
A phase field model of a crack front propagating in a three dimensional brittle material is used to study the fractographic patterns induced by the branching instability. The numerical results of this model give rise to crack surfaces that…
We develop a theory for drying-induced stresses in sessile, poroelastic drops undergoing evaporation on rigid surfaces. Using a lubrication-like approximation, the governing equations of three-dimensional nonlinear poroelasticity are…