Related papers: Steady-State Creep Analysis of Pressurized Pipe We…
We consider a model proposed by one of the authors for a type of plastic instability found in creep experiments which reproduces a number of experimentally observed features. The model consists of three coupled non-linear differential…
In this letter, we develop a framework to study the mechanical response of athermal amorphous solids via a coupling of mesoscale and microscopic models. Using measurements of coarse grained quantities from simulations of dense disordered…
It is recalled that stress-strain incremental modelling is a common feature of most theoretical description of the mechanical behaviour of granular material. An other commonly accepted characteristics of the mechanical behaviour of granular…
A streamwise-constant model is presented to investigate the basic mechanisms responsible for the change in mean flow occuring during pipe flow transition. Using a single forced momentum balance equation, we show that the shape of the…
The increased friction caused by turbulence is a significant contributor to energy consumption in the fluid-transport and piping industries. Here we describe a passive approach to reduce friction: we show that a local increase in streamwise…
We present creep experiments on fiber composite materials with controlled heterogeneity. Recorded strain rates and acoustic emission rates exhibit a power law relaxation in the primary creep regime (Andrade law) followed by a power law…
We report two-dimensional discrete dislocation dynamics simulations of combined dislocation glide and climb leading to `power-law' creep in a model aluminum crystal. The approach fully accounts for matter transport due to vacancy diffusion…
A scaling analysis is undertaken for the load balance in sliding friction in the hydrodynamic lubrication regime, with a particular emphasis on power-law shear-thinning typical of a structured liquid. It is argued that the shear-thinning…
We study the rheological behavior of concentrated granular suspensions of simple spherical particles. Under controlled stress, the system exhibits an S-shaped flow curve (stress vs. shear rate) with a negative slope in between the…
Measuring stress levels in loaded structures is crucial to assess and monitor their health, and to predict the length of their remaining structural life. However, measuring stress non-destructively has proved quite challenging. Many…
The reporting and evaluation of creep tests of concrete is complicated by the fact that creep is significant even for the shortest observable load durations. Compared to the strain after 0.1 s load duration, the strain at 2 hour duration is…
Quasi-static strain-controlled measurements of stress vs strain curves in macroscopic amorphous solids result in a nonlinear looking curve that ends up either in mechanical collapse or in a steady-state with fluctuations around a mean…
Although the behavior of entangled polymers in startup shear flows with constant shear rates has been thoroughly investigated, the response under creep has not been frequently considered. In this study, primitive chain network simulations,…
The stress-induced yielding scenario of colloidal gels is investigated under rough boundary conditions by means of rheometry coupled to local velocity measurements. Under an applied shear stress, the fluidization of gels made of attractive…
A model-based description of the scaling and radial location of turbulent fluctuations in turbulent pipe flow is presented and used to illuminate the scaling behaviour of the very large scale motions. The model is derived by treating the…
Ramp compression experiment are used to deduce the relation between compression and normal stress in a material, by measuring how a compression wave evolves as it propagates through different thicknesses of the sample material. The…
We extend our earlier shear-transformation-zone (STZ) theory of amorphous plasticity to include the effects of thermally assisted molecular rearrangements. This version of our theory is a substantial revision and generalization of…
To model rupture dynamics, a friction law must be assumed. Commonly used constitutive laws for modeling friction include slip-weakening laws which are characterized by a drop from static to dynamic frictional stress. Within this framework,…
We develop a one-dimensional network model to predict the steady-state distribution of yield-stress fluids in branched pipe manifolds under wall-slip conditions. The model accounts for major friction losses between junctions and…
We show that, based on the critical state model for flux-line pinning in hard superconductors, one can assess the magnetic moment relaxation induced by the oscillations of a perpendicular magnetic field. Our theory follows a recent proposal…