Related papers: Ultra Bright LED Light Injection Calibration Syste…
The use of liquid helium and neon as scintillators for neutrino detection is investigated. Several unique properties of these cryogens make them promising candidates for real-time solar neutrino spectroscopy: large ultraviolet scintillation…
MINOS is a two-detector on-axis experiment based at Fermilab. The NuMI neutrino beam encounters the MINOS Near Detector 1 km downstream before travelling 734 km through the Earth's crust, to reach the Far Detector located at the Soudan…
In the case of underground experiments for neutrino physics or rare event searches, the background caused by cosmic muons contributes significantly and therefore must be identified and rejected. We proposed and optimized a new detector…
The Hyper-Kamiokande neutrino detector is set to begin construction in 2020, succeeding Super-Kamiokande as the world's largest water Cerenkov detector. Research and development are well underway for an integrated light injection system for…
A custom LED driver producing light pulses with very low intensity and O(10 ns) duration was designed and constructed. A microcontroller was employed to handle the amplitudes and the repetition rates of the output pulses. In addition, it…
Scintillating homogeneous detectors represent the state of the art in electromagnetic calorimetry. Moreover, the currently neglected crystalline nature of the most common inorganic scintillators can be exploited to achieve an outstanding…
Short baseline oscillations of neutrinos (nue and nuebar) due to active-sterile (a-s) mixing can be observed explicitly using MeV neutrino beams and existing/planned neutrino detectors. The typical baseline/energy (L/E) of this approach…
On May 2008 the ANTARES collaboration completed the installation of a neutrino telescope in the Mediterranean Sea. This detector consists of a tridimensional array of almost 900 photomultipliers (PMTs) distributed in 12 lines. These PMTs…
A system based on commercially available items, such as a laser diode, emitting in the visible range $\sim 400$ nm,and multimode fiber patches, fused fiber splitters and optical switches may be assembled,for time calibration of…
I will present the status of the long baseline neutrino oscillation experiment MINOS at Fermi National Accelerator Laboratory (Fermilab). I will summarize the status of the detector and beam construction, the expected event rates and…
The MINERvA experiment is designed to perform precision studies of neutrino-nucleus scattering using $\nu_\mu$ and ${\bar\nu}_\mu$ neutrinos incident at 1-20 GeV in the NuMI beam at Fermilab. This article presents a detailed description of…
Measurement of stray light in a complex optical system can be a complex task. We developed a method to measure coherent stray light inside an assembled device, determining all stray light sources and their relative contribution. The method…
The use of low-temperature detectors, such as cryogenic calorimeters, has pioneered the recent advancements in low-energy rare event searches. These detectors provide a low-noise environment essential for the direct detection of dark matter…
The present Compact Muon Solenoid silicon pixel tracking system has been designed for a peak luminosity of 1034cm-2s-1 and total dose corresponding to two years of the Large Hadron Collider (LHC) operation. With the steady increase of the…
We have developed a new laser-based time calibration system for the MEG II timing counter dedicated to timing measurement of positrons. The detector requires precise timing alignment between $\sim\,$500 scintillation counters. In this…
The IceCube Neutrino Observatory, instrumenting about 1 km$^3$ of deep, glacial ice at the geographic South Pole, is due to be enhanced with the IceCube Upgrade. The IceCube Upgrade, to be deployed during the 2025/26 Antarctic summer…
With the rise of neutrino astronomy using large-volume detector arrays, calibration improvements of optical media and photosensors have emerged as significant means to reduce detector systematics. To improve understanding of the detector…
The MINOS long-baseline experiment is using the NuMI neutrino beam to make precise measurements of neutrino flavor oscillations in the "atmospheric" neutrino sector. MINOS observes the $\nu_\mu$ disappearance oscillations seen in…
Opaque scintillators are designed to have a short scattering length such that scintillation photons are probabilistically confined to a small region of space about their origin. The benefit of this feature is that information on the…
In order to develop a high spatial resolution (micron level) thermal neutron detector, a detector assembly composed of cerium doped lithium glass microfibers, each with a diameter of 1\,$\mu$m, is proposed, where the neutron absorption…