Related papers: Effective Dynamic Range in Measurements with Flash…
For the upgrade of the inner tracker of the BESIII spectrometer, planned for 2018, a lightweight tracker based on an innovative Cylindrical Gas Electron Multiplier (CGEM) detector is now under development. The analogue readout of the CGEM…
Intensity-modulation direct-detection links must support increasing baudrates and transmission distances while operating under stringent power and cost constraints. However, as data rates and reaches increase, chromatic dispersion induces…
We present an improvement of the phase distance correlation (PDC) periodogram to account for uncertainties in the time-series data. The PDC periodogram introduced in our previous papers is based on the statistical concept of distance…
Over nearly two decades, Differential Dynamic Microscopy (DDM) has become a standard technique for extracting dynamic correlation functions from time-lapse microscopy data, with applications spanning colloidal suspensions, polymer…
Silicon photo-multipliers (SiPM) have been replacing traditional photomultiplier tubes in most light sensing applications. However, when large detection surface coverage is needed, photomultipliers (PMTs) are still the preferred choice. The…
New LED-transmitters have been used to develop a new method of fast analog transmission of PMT pulses over large distances. The transmitters, consisting basically of InGaAsP LEDs with the maximum emission of light at 1300 nm, allow the…
A real-time ranging lidar with 0.1 Mega Hertz update rate and few-micrometer resolution incorporating dispersive Fourier transformation and instantaneous microwave frequency measurement is proposed and demonstrated. As time-stretched…
We introduce a novel direct calibration algorithm to address phase delay, gain, and offset mismatches in Analog-to-Digital Converter (ADC) time interleaving systems. These mismatches, common in high-speed data acquisition, degrade system…
The FCC integrated programme comprises an $\rm e^+e^-$ high-luminosity circular collider that will produce very large samples of data in an energy range $88 \le \sqrt{s} \le 365$ GeV, followed by a high-energy $\rm pp$ machine that, with…
The current battery-powered fault detection system for vibration monitoring has a rather limited lifetime. This is because the high-frequency sampling (typically tens of kilo-Hertz) required for vibration monitoring results in high energy…
The possibility of using electron beam phase space manipulations to support a free-electron laser accelerator design optimization has motivated our research. An on-going program demonstrating the exchange of transverse horizontal and…
The active reflector is one of the three main innovations of the Five-hundred-meter Aperture Spherical radio Telescope (FAST). The deformation of such a huge spherically shaped reflector into different transient parabolic shapes is achieved…
The ALICE experiment at the Large Hadron Collider (LHC) proposes major detector upgrades to fully exploit the increase of the luminosity of the LHC in RUN~3 and to extend the physics reach for rare probes at low transverse momentum. The…
This paper proposes a novel fluid antenna system (FAS)-enabled architecture to improve energy efficiency (EE) without sacrificing capacity. Specifically, we integrate FAS into cell-free massive MIMO systems to counteract low-resolution…
Efficient telecom frequency conversion (TFC) in atomic systems is crucial for integrating atom-based quantum nodes into low-loss fiber-optic quantum networks. Here, we demonstrate high-efficiency TFC from 795 nm to 1367 nm in a cold 87Rb…
A coherent, short-length reference arm reflectometer, which utilizes a 76-MHz repetition rate mode-locked fiber laser, was investigated experimentally for long fiber links (> 10 km). The reflectometer combines the advantages of optical…
Background: FLASH radiotherapy is a treatment regime that delivers therapeutic dose to tumors at an ultra-high dose rate while maintaining adequate normal tissue sparing. However, a comprehensive understanding of the underlying mechanisms,…
Scientific applications are often irregular and characterized by large computationally-intensive parallel loops. Dynamic loop scheduling (DLS) techniques improve the performance of computationally-intensive scientific applications via load…
FLASH radiotherapy necessitates the development of advanced Quality Assurance methods and detectors for accurate and online monitoring of the radiation field. This study introduces enhanced time-resolution detection systems and methods…
A front-end readout electronics system has been developed for silicon strip detectors. The system uses an application specific integrated circuit (ASIC) ATHED to realize multi-channel E&T measurement. The slow control of ASIC chips is…