Related papers: The MINOS Light Injection Calibration System
We describe here a proposal for a light injection calibration system for the MINOS detectors based on ultra bright blue LEDs as the light source. We have shown that these LEDs are bright enough to span over two orders of magnitude in light…
MINOS is a long baseline neutrino oscillation experiment that uses two detectors separated by 734 km. The readout systems used for the two detectors are different and have to be independently calibrated. To verify and make a direct…
The MINOS long baseline experiment has been collecting neutrino beam data since March 2005 and has accumulated 3 x 10^{20} protons-on-target (POT) to date. MINOS uses Fermilab's NuMI neutrino beam which is measured by two steel-scintillator…
MINOS is a long baseline neutrino oscillation experiment designed to make precision measurements of the neutrino mixing parameters associated with the atmospheric neutrino mass splitting. Using a neutrino beam from the Main Injector (NuMI)…
The Main Injector Neutrino Oscillation Search (MINOS) experiment uses an accelerator-produced neutrino beam to perform precision measurements of the neutrino oscillation parameters in the "atmospheric neutrino" sector associated with muon…
The MINOS experiment is a long-baseline neutrino experiment designed to study neutrino behaviour, in particular the phenomenon of neutrino oscillations. MINOS sends the NuMI neutrino beam through two detectors, a Near Detector 1 km…
The MINOS experiment has used the world's most powerful neutrino beam to make precision neutrino oscillation measurements. By observing the disappearance of muon neutrinos, MINOS has made the world's most precise measurement of the larger…
A light-emitting diode (LED) pulser for testing the low-rate response of a photomultiplier tube (PMT) to scintillator-like pulses has been designed, developed, and implemented. This pulser is intended to simulate 80 ns full width at half…
The calibration of the ICARUS photo-detection system is based on a low power laser diode at 405 nm. Laser pulses arrive to one optical switch and then are sent to 36 UHV flanges, by 20 meters long optical patches. Light is then delivered to…
The Main Injector Neutrino Oscillation search (MINOS) uses two detectors separated by 735km to measure a beam of neutrinos created by the Neutrinos at the Main Injector (NuMI) facility at Fermi National Accelerator Laboratory. The…
After a brief introduction to neutrino oscillations and a review of the world knowledge of neutrino oscillation parameters, we introduce two current neutrino oscillation experiments, MINOS and MiniBooNE. MINOS makes precise measurements of…
I will present the status of the long baseline neutrino oscillation experiment MINOS at Fermi National Accelerator Laboratory (Fermilab). I will summarize the status of the detector and beam construction, the expected event rates and…
The MINOS long baseline neutrino oscillation experiment is comprised of three calorimeters, a Near Detector at FNAL, a Far Detector at the Soudan mine in northern Minnesota, and a Calibration Detector in a test beam at CERN. The light…
A UV laser calibration system is developed for the Jiangmen Underground Neutrino Observatory (JUNO), a 20-kton liquid scintillator-based, long baseline reactor anti-neutrino experiment. This system is capable of delivering fast laser pulses…
The Main Injector Neutrino Oscillation Search (MINOS) experiment's primary goal is the precision measurement of the neutrino oscillation parameters in the atmospheric neutrino sector. This long-baseline experiment uses Fermilab's NuMI beam,…
As of December 2005, the MINOS long-baseline neutrino oscillation experiment collected data with an exposure of $0.93\times10^{20}$ protons on target. Preliminary analysis of these data reveals a result inconsistent with a no-oscillation…
The MINOS long-baseline experiment is using the NuMI neutrino beam to make precise measurements of neutrino flavor oscillations in the "atmospheric" neutrino sector. MINOS observes the $\nu_\mu$ disappearance oscillations seen in…
The JSNS2-II (the second phase of JSNS2, J-PARC Sterile Neutrino Search at J-PARC Spallation Neutron Source) is an experiment aimed at searching for sterile neutrinos. This experiment has entered its second phase, employing two liquid…
A LED-based fiber calibration system for the ProtoDUNE-Dual Phase (DP) photon detection system (PDS) has been designed and validated. ProtoDUNE-DP is a 6x6x6 m3 liquid argon time-projection-chamber currently being installed at the Neutrino…
The MINOS experiment observes the NuMI beam produced by the Main Injector accelerator at two detector stations, one 1 km and the other 735 km from the neutrino production target. From the disappearance of neutrinos in flight between the two…