Related papers: TAC Proposal for Fundamental and Applied Research

Main parameters of linac-ring type $phi$-factory proposed as the part of the Turkic Accelerator Complex (TAC) in the framework of ATAM Science Sity Project are discussed. Two sets of parameters, corresponding to E=130(260) MeV for electron…

Recently, the Turkic Accelerator Complex (TAC) is proposed as a regional facility for accelerator based fundamental and applied research. The complex will include linac on ring type electron-positron collider as a phi, charm and tau…

The Turkic Accelerator Complex (TAC) project has been developed with the support of the Turkish State Planning Organization by the collaboration of 10 Turkish universities. The complex is planned to have four main facilities, namely: SASE…

The TAC (Turkish Accelerator Center) IR FEL Oscillator facility, which has been supported by Turkish State Planning Organization (SPO) since 2006, will be based on a 15-40 MeV electron linac accompanying two different undulators with 2.5 cm…

Main parameters of the linac-ring type charm-tau factory are discussed. Different sets of parameters for an electron linac and a positron ring have been considered. It is shown that L=10^33 cm-2 s-1 and even more can be achieved. The…

A SASE FEL facility was first proposed in Feasibility Report of the TAC (Turkish Accelerator Center) project in 2000. Conceptual Design Report (CDR) of the project was completed in 2005. Technical Design Report (TDR) studies of TAC were…

A beam dynamics design of 352.2 MHz Radio-Frequency Quadrupole (RFQ) of Turkish Accelerator Center (TAC) project which accelerates continuous wave (CW) proton beam with 30 mA current from 50 keV to 3 MeV kinetic energy has been performed in…

Parameters for linac-ring type e^{-}e^{+} colliders with sqrt(s)=1020 MeV (phi factory), 3770 MeV (charm factory) and 4.2 GeV (tau factory) are discussed. It is shown that luminosities of the order of 10^{34} cm^{-2}s^{-1} can be achieved.

Main parameters and the physics search potentials of the linac-ring type lepton-hadron and photon-hadron colliders are discussed. The THERA (TESLA on HERA), NLC-LHC and CLIC-VLHC proposals are considered.

The JAERI/KEK Joint Project for the high-intensity proton accelerator facility has been proposed with a superconducting (SC) linac option from 400 MeV to 600MeV. System design of the SC linac has been carried out based on the…

Linac-ring type colliders will open new windows for both energy frontier and particle factories. Concerning the first direction, these machines seem to be a sole way to TeV scale in lepton-hadron collisison at constituent level. An…

The HALHF collaboration has discussed a new baseline for the project, taking into account comments from the accelerator community on various aspects of the original design. In particular, these concerned the practicality of the dual-purpose…

The construction of the 60-MeV proton linac has started as a low-energy front of the KEK/JAERI Joint Project for a high-intensity proton accelerator facility at KEK. The accelerating frequency is 324 MHz. Five UHF klystrons are used as an…

The conceptual design of a Variable-Phase Asynchronous Cyclotron (VPAC) is describe, which provides longitudinal bunch compression of accelerated proton or ion beams, and thus, permits high current acceleration at higher accelerator…

Project-X is a proposed project to be built at Fermi National Accelerator Laboratory with several potential missions. A primary part of the Project-X accelerator chain is a Superconducting linac, and In October 2009 a workshop was held to…

A 5-MeV RFQ designed for a proton current up to 100-mA CW is now under construction as part of the High Intensity Proton Injector project (IPHI). Its computed transmission is greater than 99 %. The main goals of the project are to verify…

ANL and the National Science Center "Kharkov Institute of Physics Technology" (NSC KIPT, Kharkov, Ukraine) jointly proposed to design and build a 100MeV/100KW linear accelerator which will be used to drive the neutron source subcritical…

A proposal for a 10-120 mA proton linac employing superconducting beta-graded, CERN type, four cell cavities at 352 MHz is presented. The high energy part (100 MeV-1 GeV) of the machine is split in three beta-graded sections, and transverse…

The first Part contains the invited talk given at the First International Workshop on Linac-Ring Type ep and $gamma$p Colliders (9-11 April 1997, Ankara, Turkey). Four known types of colliders, which may give an opportunity to achieve TeV…

The present status of suggested linac-ring type ep and gamma-p colliders is reviewed. The main parameters of these machines as well as e-nucleus and gamma-nucleus colliders are considered. It is shown that sufficiently high luminosities may…