Related papers: The finite mass beamsplitter in high power interfe…
We derive generic phase and amplitude coupling relations for beam splitters-combiners that couple a single port with three output ports or input ports, respectively. We apply the coupling relations to a reflection grating that serves as a…
We propose a simple way to improve the laser gravitational-wave detectors sensitivity by means of reduction of the number of reflective coating layers of the core optics mirrors. This effects in the proportional decrease of the coating…
Here we introduce interferometric devices by combining optical feedback (cavities) with unbiased multiports, which unlike traditional beam dividers, allow light to reflect back out of the port from which it originated. By replacing the…
Laser interferometers with high circulating power and suspended optics, such as the LIGO gravitational wave detectors, experience an optomechanical coupling effect known as a parametric instability: the runaway excitation of a mechanical…
An experimental realization of a compact, high-power spectral beamsplitter for nearly equal frequencies and identical polarization based on two-beam interference in a free-space Mach-Zehnder interferometer is presented. We demonstrate the…
We theoretically analyze the quantum noise of signal-recycled laser interferometric gravitational-wave detectors with additional input and output optics, namely frequency-dependent squeezing of the vacuum entering the dark port and…
Squeezed light is injected into the dark port of gravitational wave interferometers, in order to reduce the quantum noise. A fraction of the interferometer output light can reach the OPO due to sub-optimal isolation of the squeezing…
We analyze the radiation pressure induced interaction of mirror motion and light fields in Michelson-type interferometers used for the detection of gravitational waves and for fundamental research in table-top quantum optomechanical…
The shot-noise limited sensitivity of Michelson-type laser interferometers with Fabry-Perot arm cavities can be increased by the so-called power-recycling technique. In such a scheme the power-recycling cavity is optically coupled with the…
Quantum input-output relations for a generic $n$-port ring cavity are obtained by modeling the ring as a cascade of $n$ interlinked beam splitters. Cavity response to a beam impinging on one port is studied as a function of the…
Long baseline laser interferometers used for gravitational wave detection have proven to be very complicated to control. In order to have sufficient sensitivity to astrophysical gravitational waves, a set of multiple coupled optical…
Optical beamsplitters with similar properties for orthogonal, linear polarisation modes are required for realising polarisation-based speedmeter schemes to reduce back-action noise in gravitational-wave interferometers. In this paper, we…
The large scale interferometric gravitational wave detectors consist of Fabry-Perot cavities operating at very high powers ranging from tens of kW to MW for next generations. The high powers may result in several nonlinear effects which…
In this work, we investigate a tool for hybrid quantum systems that implements a transducer to map small position changes of a micro-mechanical membrane onto the polarization of a laser beam. This is achieved with an interferometric setup…
Michelson-type laser-interferometric gravitational-wave (GW) observatories employ very high light powers as well as transmissively- coupled Fabry-Perot arm resonators in order to realize high measurement sensitivities. Due to the absorption…
The Michelson interferometric phase detection resolution can be enhanced by replacing conventional beam splitters with novel directionally unbiased four-port scatterers, such as Grover coins. We present a quantitative analysis of the…
The sensitivity of next-generation gravitational-wave detectors such as Advanced LIGO and LCGT should be limited mostly by quantum noise with an expected technical progress to reduce seismic noise and thermal noise. Those detectors will…
We consider dephasing in the electronic Mach-Zehnder interferometer strongly coupled to current noise created by a voltage biased quantum point contact (QPC). We find the visibility of Aharonov-Bohm oscillations as a function voltage bias…
An influence of nonlinear interference processes at quantum transitions under strong resonance electromagnetic fields on absorption, amplification and refractive indices as well as on four-wave mixing processes is investigated. Doppler…
Heterodyne interferometry for precision science often comes with an optical phase modulation, for example, for intersatellite clock noise transfer for gravitational wave (GW) detectors in space, exemplified by the Laser Interferometer Space…