Related papers: Dual recycling for GEO600
In this article we study a particular method of detection of chirp signals from coalescing compact binary stars -- the so-called dynamical tuning, i.e. amplification of the signal via tracking of its instantaneous frequency by the tuning of…
The possible design of QND gravitational-wave detector based on speed meter principle is considered with respect to optical losses. The detailed analysis of speed meter interferometer is performed and the ultimate sensitivity that can be…
Results from two optical-fiber gravitational-wave interferometric detectors are reported. The detector design is very small, cheap and simple to build and operate. Using two detectors has permitted various tests of the design principles as…
Recently, observational searches for gravitational wave background (GWB) have developed and given direct and indirect constraints on the energy density of GWB in a broad range of frequencies. These constraints have already rejected some…
The design of new low-mechanical-loss, high reflectivity mirrors is crucial in the development of the next generation of gravitational-wave observatories. Currently, the state-of-the-art amorphous multilayer reflective coatings which are…
Time-delay interferometry is put forward to improve the signal-to-noise ratio of space-borne gravitational wave detectors by canceling the large laser phase noise with different combinations of measured data. Based on the Michelson data…
Interferometric gravitational wave detectors use mirrors whose substrates are formed from materials of low intrinsic mechanical dissipation. The two most likely choices for the test masses in future advanced detectors are fused silica or…
We demonstrate the applicability of the EPR entanglement squeezing scheme for enhancing the shot-noise-limited sensitivity of a detuned dual-recycled Michelson interferometers. In particular, this scheme is applied to the GEO\,600…
Inspiraling compact binaries have been identified as one of the most promising sources of gravitational waves for interferometric detectors. Most of these binaries are expected to have circularized by the time their gravitational waves…
We analyze the radiation pressure induced interaction of mirror motion and light fields in Michelson-type interferometers used for the detection of gravitational waves and for fundamental research in table-top quantum optomechanical…
We propose a double-resonant interferometric strategy for axion dark matter detection that combines microwave circuit resonance with Fabry--P\'erot optical enhancement. In a strong magnetic field, axion--photon mixing induces a weak…
Information recycling has been shown to improve the sensitivity of atom interferometers by exploiting atom-light entanglement. In this paper, we apply information recycling to an interferometer where the input quantum state has been…
We study frequency dependent (FD) input-output schemes for signal-recycling interferometers, the baseline design of Advanced LIGO and the current configuration of GEO 600. Complementary to a recent proposal by Harms et al. to use FD input…
We consider improving the sensitivity of future interferometric gravitational-wave detectors by simultaneously injecting two squeezed vacuums (light), filtered through a resonant Fabry-Perot cavity, into the dark port of the…
Ground-based gravitational wave detectors use laser interferometry to detect the minuscule distance change between test masses caused by gravitational waves. Stray light that scatters back into the interferometer causes transient signals…
We show that back-action noise in interferometric measurements such as gravitational-waves detectors can be completely suppressed by a local control of mirrors motion. An optomechanical sensor with an optimized measurement strategy is used…
High-resolution seismic reflections are essential for imaging and monitoring applications. In seismic land surveys using sources and receivers at the surface, surface waves often dominate, masking the reflections. In this study, we…
In order to achieve full detection sensitivity at low frequencies, the mirrors of interferometric gravitational wave detectors must be isolated from seismic noise. The VIRGO vibration isolator, called 'superattenuator', is fully effective…
Gravitational wave detectors such as KAGRA, a 3-km long underground laser interferometer in Japan, require elaborate passive and active seismic isolation of their mirrors. With the aim of detecting passing gravitational waves that create a…
We propose a new implementation of a quantum speed meter QND measurement scheme. It employs two independent optical readouts of the interferometer test masses, featuring strongly different values of the bandwidths $\gamma_{1,2}$ and of the…