Related papers: Algebraic approach to time-delay data analysis for…
The population of stellar origin black hole binaries (SOBHBs) detected by existing ground-based gravitational wave detectors is an exciting target for the future space-based Laser Interferometer Space Antenna (LISA). LISA is sensitive to…
A crucial challenge to the ongoing endeavor of spaceborne gravitational wave (GW) detection resides in the laser phase noise, typically 7 to 8 orders of magnitude above the inevitable noise. The arm locking technique was proposed to…
One of the main sources of gravitational waves for the LISA space-borne interferometer are galactic binary systems. The waveforms for these sources are represented by eight parameters, of which four are extrinsic, and four are intrinsic to…
The sensitivity of searches for astrophysical transients in data from the LIGO is generally limited by the presence of transient, non-Gaussian noise artifacts, which occur at a high-enough rate such that accidental coincidence across…
We describe a simple framework to assess the LISA scientific performance (more specifically, its sensitivity and expected parameter-estimation precision for prescribed gravitational-wave signals) under the assumption of failure of one or…
The Laser Interferometer Space Antenna (LISA) is being designed to detect and study in detail gravitational waves from sources throughout the Universe such as massive black hole binaries. The conceptual formulation of the LISA space-borne…
Radio interferometric (RI) data are noisy under-sampled spatial Fourier components of the unknown radio sky affected by direction-dependent antenna gains. Failure to model these antenna gains accurately results in a radio sky estimate with…
The ESA/NASA joint LISA (laser interferometer space antenna) mission is designed to detect gravitational waves, which relies crucially on maintaining three-spacecraft constellation as close to an equilateral triangle with a designed…
TianQin is a proposed space-based mission for gravitational wave detection, employing a constellation of three drag-free satellites in high Earth orbits to form a laser interferometric observatory. A critical technical challenge is…
The detection of galactic binaries as sources of gravitational waves promises an unprecedented wealth of information about these systems, but also raises several challenges in signal processing. In particular the large number of expected…
Recently, the configuration using atomic interferometers (AIs) had been suggested for the detection of gravitational waves. A new AI with some additional laser pulses for implementing large momentum transfer was also put forward, in order…
The Laser Interferometer Space Antenna (LISA) guarantees the detection of gravitational waves by monitoring a handful of known nearby galactic binary systems, the so-called ``verification binaries''. We consider the most updated information…
The future space mission LISA will observe a wealth of gravitational-wave sources at millihertz frequencies. Of these, the extreme-mass-ratio inspirals of compact objects into massive black holes are the only sources that combine the…
Space-based interferometric gravitational wave instruments such as the ESA/NASA Laser Interferometer Space Antenna (LISA) observe gravitational waves by measuring changes in the light travel time between widely-separated spacecraft. One…
This paper considers a noisy data structure recovery problem. The goal is to investigate the following question: Given a noisy observation of a permuted data set, according to which permutation was the original data sorted? The focus is on…
An important step of seismic data processing is removing noise, including interference due to simultaneous and blended sources, from the recorded data. Traditional methods are time-consuming to apply as they often require manual choosing of…
In the detection of gravitational waves in space, the arm lengths between spacecraft are not equal due to their orbital motion. Consequently, the equal arm length Michelson interferometer used in Earth laboratories is not suitable for…
High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made…
The orbiting LISA instrument is designed to detect gravitational waves in the millihertz band, produced by sources including galactic binaries and extreme mass ratio inspirals, among others. The detector consists of three spacecraft, each…
The frequency stability achieved by an optical atomic clock ultimately depends on the coherence of its local oscillator. Even the best ultrastable lasers only allow interrogation times of a few seconds, at present. Here we present a…