Related papers: Parametric Oscillatory Instability in Fabry-Perot …
Noise usually has an unwelcome influence on system performance. For instance, noise inevitably affects the low-frequency mechanical freedom in optomechanical experiments. However, we investigate here the beneficial effects of thermal noise…
With the support of hybrid-kinetic simulations and analytic theory, we describe the nonlinear behaviour of long-wavelength non-propagating (NP) modes and fast magnetosonic waves in high-$\beta$ collisionless plasmas, with particular…
Despite recent progress in nonlinear optics in wavelength-scale resonators, there are still open questions on the possibility of parametric oscillation in such resonators. We present a general approach to predict the behavior and estimate…
We have measured the photothermal effect in a single cross-polarized interferometer at audio frequencies (5 Hz - 4 kHz). In a Fabry-Perot interferometer, light in one polarization is chopped to periodically heat the interferometer mirrors,…
A fundamental limit to the sensitivity of optical interferometers is imposed by Brownian thermal fluctuations of the mirrors' surfaces. This thermal noise can be reduced by using larger beams which "average out" the random fluctuations of…
Three-mode parametric-instabilities risk stable operation of gravitational-wave detectors. Instabilities occur through time varying radiation-pressure distributions, derived from beating between two optical modes, exciting mirror acoustic…
Cross-phase modulation instability (XPMI) is experimentally observed in a fiber ring cavity with net normal dispersion and mode-locked by long fiber taper. The taper is deposited with reduced graphene oxide, which can decrease the threshold…
The interplay of such cornerstones of modern nonlinear fiber optics as a nonlinearity, stochasticity and polarization leads to variety of the noise induced instabilities including polarization attraction and escape phenomena harnessing of…
We present an analytical and numerical investigation into the phenomenon of filter-induced modulation instability in passive hybrid optical resonators exhibiting quadratic and cubic nonlinearity. We show that asymmetric spectral losses,…
Optical multilayer coatings of high-reflective mirrors significantly determine the properties of Fabry-Perot resonators. Thermal (Brownian) noise in these coatings produce excess phase noise which can seriously degrade the sensitivity of…
Forced oscillation (FO) is a significant concern threating the power system stability. Its mechanisms are mostly studied via linear models. However, FO amplitude is increasing, e.g., Nordic and Western American FOs, which can stimulate…
In this paper intermodal modulational instability (IM-MI) is analyzed in a multimode fiber where several spatial and polarization modes propagate. The coupled nonlinear Schr\"{o}dinger equations describing the modal evolution in the fiber…
We study the effect of finite size and misalignment on a fundamental optomechanical setup: a Fabry-P\'erot cavity with one fixed and one moveable mirror. We describe in detail light confinement under these real world imperfections and…
The sensitivity of high-precision interferometric measurements can be limited by Brownian noise within dielectric mirror coatings. This occurs, for instance, in the optical resonators of gravitational wave detectors where the noise can be…
The influence of the phase fluctuation of the pump laser on the phase-correlation between the signal and idler modes of the output fields from as non-degenerate optical parametric oscillator operating above oscillation threshold was…
Acoustic and optical ferromagnetic resonance (FMR) in the interlayer exchange coupled Fe$_{20}$Ni$_{80}$/Co bilayer have been investigated. In the optical mode, unexpected increasing tendencies of peak value at the resonance frequency has…
An optical technique based on stability transfer among modes of a monolithic optical microresonator is proposed for long therm frequency stabilization of a radiofrequency (RF) oscillator. We show that locking two resonator modes,…
Thermal lensing in resonant optical interferometers such as those used for gravitational wave detection is a concern due to the negative impact on control signals and instrument sensitivity. In this paper we describe a method for monitoring…
In a follow-up effort to our prior report on the optical transmission of a moving Fabry-Perot interferometer \cite{Pyvovar}, this work seeks to establish a general framework that describes the transmission and reflection properties of a…
We present detailed studies of the effect of polarization on thermal-induced mode instability (MI) in ytterbium-doped fiber amplifiers. Based on a steady-state theoretical model, which takes both electric fields along the two principal axes…