Related papers: Coverage and Connectivity in Three-Dimensional Net…
Network densification and heterogenisation through the deployment of small cellular access points (picocells and femtocells) are seen as key mechanisms in handling the exponential increase in cellular data traffic. Modelling such networks…
In order to study the fundamental limits of network densification, we look at the spatial spectral efficiency gain achieved when densely deployed communication devices embedded in the $d$-dimensional Euclidean space are optimally `matched'…
In order to make full use of geographic routing techniques developed for large scale networks, nodes must be localized. However, localization and virtual localization techniques in sensor networks are dependent either on expensive and…
For reliable and efficient communications of aerial platforms, such as unmanned aerial vehicles (UAVs), the cellular network is envisioned to provide connectivity for the aerial and ground user equipment (GUE) simultaneously, which brings…
Disordered complex networks are of fundamental interest as stochastic models for information transmission over wireless networks. Well-known networks based on the Poisson point process model have limitations vis-a-vis network efficiency,…
We consider a distributed edge computing scenario consisting of several wireless nodes that are located over an area of interest. Specifically, some of the "master" nodes are tasked to sense the environment (e.g., by acquiring images or…
A wireless sensor network (WSN) consists of multiple wireless sensor nodes that communicate each other to fulfill a particular task. In this paper, we emphasize on the networks whose deployments admit lower dimensional substructures, such…
Multi-antenna techniques capable of exploiting the elevation dimension are anticipated to be an important air-interface enhancement targeted to handle the expected growth in mobile traffic. In order to enable the development and evaluation…
The connectivity properties of a weight-bearing network are exploited to enhance it's capacity. We study a 2-d network of sites where the weight-bearing capacity of a given site depends on the capacities of the sites connected to it in the…
In optimizing the topology of wireless networks built of a dynamic set of spatially embedded agents, there are many trade-offs to be dealt with. The network should preferably be as small (in the sense that the average, or maximal,…
When planning a 5G network in the sub-6GHz bands, similar cell planning techniques to LTE can be applied. Looking at the Australian environment, the n78 band (3.3-3.8GHz TDD) is approximately 1GHz higher than the 2.6GHz band used in…
Devices in a device-to-device (D2D) network operating in sub-THz frequencies require knowledge of the spatial channel that connects them to their peers. Acquiring such high dimensional channel state information entails large overhead, which…
The study of complex networks is a significant development in modern science, and has enriched the social sciences, biology, physics, and computer science. Models and algorithms for such networks are pervasive in our society, and impact…
This paper deals with the accomplishment of total area coverage of an arbitrary region using sensors with a finite sensing radius of rs. For a given region, we aim to obtain a deterministic placement of sensors which, apart from ensuring…
Enabling vertical use cases for the sixth generation (6G) wireless networks, such as automated manufacturing, immersive extended reality (XR), and self-driving fleets, will require network designs that meet reliability and latency targets…
Distributed massive MIMO (D-mMIMO) has been considered for future networks as it holds the potential to offer superior capacity while enabling energy savings in the network. A D-mMIMO system has multiple arrays. Optimizing the locations of…
Stereo-LiDAR fusion is a promising task in that we can utilize two different types of 3D perceptions for practical usage -- dense 3D information (stereo cameras) and highly-accurate sparse point clouds (LiDAR). However, due to their…
In multiple-input single-output (MISO) wireless power transfer (WPT) via magnetic resonant coupling (MRC), multiple transmitters are deployed to enhance the efficiency of power transfer to the electric load at a single receiver by jointly…
Lattices are important as models for the node locations in wireless networks for two main reasons: (1) When network designers have control over the placement of the nodes, they often prefer a regular arrangement in a lattice for coverage…
Using drone base stations (drone-BSs) in wireless networks has started attracting attention. Drone-BSs can assist the ground BSs in both capacity and coverage enhancement. One of the important problems about integrating drone-BSs to…