Related papers: Surface Influence on Flux Penetration into HTS Bul…
We have developed a set of experimental techniques with levitation to investigate the macroscopic magnetic properties of bulk HTS: (i) resonance oscillation technique; (ii) high speed magnetic rotor technique; (iii) the method of viscous…
Minimization of ac losses is essential for economic operation of high-temperature superconductor (HTS) ac power cables. A favorable configuration for the phase conductor of such cables has two counter-wound layers of HTS tape-shaped wires…
We report the low-frequency and tunneling studies of yttrium hexaboride single crystal. Ac susceptibility at frequencies 10 - 1500 Hz has been measured in parallel to the crystal surface DC felds, H0. We found that in the DC feld H0 > Hc2…
Wetting phenomena plays an interesting role in the technological development of materials. Recently, much attention has been directed to the study of magnetic solid films. To understand, theoretically, the effect of surface on wetting and…
Surface effects on the electronic energy loss of charged particles entering a metal surface are investigated within linear-response theory, in the framework of time-dependent density functional theory. Interesting phenomena occur in the…
We investigate surface processes of magnetic patches, namely merging, splitting, emergence, and cancellation, by using an auto-detection technique. We find that merging and splitting are locally predominant in the surface level, while the…
Meniscus oscillations at interfaces between liquids, solids, and air significantly impact fluid dynamics and control. While idealized models exist, experimental data on capillary-gravity wave scattering involving meniscus effects remain…
Numerical simulations of the hysteretic ac loss in a coated superconductor with a more realistic version of architecture were performed via finite-element technique in the presence of an oscillating magnetic field. The coated superconductor…
Electrons trapped on the surface of liquid helium is an extremely clean system which holds promise for a scalable qubit platform. However, the superfluid surface is not free from fluctuations which might cause the decay and dephasing of the…
We report results of experimental studies of ac susceptibility of Nb single crystal at low frequencies in swept magnetic fields applied parallel to the surface. Analysis of the experimental data shows that the swept magnetic field…
We investigate excluded-volume effects in a bidisperse colloidal suspension near a flexible interface. Inspired by a recent experiment by Dinsmore et al. (Phys. Rev, Lett. 80, 409 (1998)), we study the adsorption of a mesoscopic bead on the…
With the advent of new fabrication technologies, time-varying metasurfaces have emerged as novel platforms for exotic waveform shaping in microwaves and optics, providing an additional degree of freedom to design dynamically controllable…
We analyse the influence of a surface viscosity on the orientational dynamics of a nematic liquid crystal subjected to an oscillatory Couette flow. Approximate analytical solutions of nematohydrodynamic equations for small flow amplitudes…
Three different porous substrates (with different pore sizes, s, and permeabilities, K) are used to examine their effect on the structure of boundary layer flow over them. The flow is characterised with single-point hot-wire measurements as…
We use a hydrodynamics theory to discuss the response of a viscous flux-line liquid to an ac perturbation applied at the surface of the sample. The theory incorporates viscoelastic effects and describes the crossover between liquid-like and…
First-principles calculations of the conventional and acoustic surface plasmons (CSPs and ASPs) on the (111) surfaces of Cu, Ag, and Au are presented. The effect of $s-d$ interband transitions on both types of plasmons is investigated by…
Surface roughness is a major contributor to performance degradation in gas turbine engines. The fan and the compressor, as the first components in the engine's air path, are especially vulnerable to the effects of surface roughness. Debris…
High velocity impact between crystalline surfaces is important for a range of material phenomena, yet a fundamental understanding of the effect of surface structure, energetics and kinetics on the underlying thermo-mechanical response…
Surface scattering of free electrons strongly modifies the electromagnetic response near the interface. Due to the inherent anisotropy of the surface scattering that necessarily reverses the normal the interface component of the electron…
We study the influence of surface roughness on the adhesion of elastic solids. Most real surfaces have roughness on many different length scales, and this fact is taken into account in our analysis. We consider in detail the case when the…