Related papers: Dynamical stability of the crack front line
Linear stability of supersonic flow over a short compression corner with ramp angles 30 and 42 is investigated using Direct Simulation Monte Carlo (DSMC) and Linear Stability Theory (LST) at Mach number 3, Reynolds number 11,200 and low…
We analyze a piece-wise linear elastic model for the propagation of a crack in a stripe geometry under mode III conditions, in the absence of dissipation. The model is continuous in the propagation direction and discrete in the…
Crack propagation is studied numerically using a continuum phase-field approach to mode III brittle fracture. The results shed light on the physics that controls the speed of accelerating cracks and the characteristic branching instability…
Recently it has been shown that when an equation that allows so-called pulled fronts in the mean-field limit is modelled with a stochastic model with a finite number $N$ of particles per correlation volume, the convergence to the speed…
We analyze the Rice-Ruina state and rate dependent friction model. The system consists of one or two blocks driven by springs with constant velocity on a dry, rough surface. Our discussion is limited to the creep-like motion, when the…
We consider planar traveling fronts between stable steady states in two-component singularly perturbed reaction-diffusion-advection equations, where a small quantity $\delta^2$ represents the ratio of diffusion coefficients. The fronts…
We report on a linear Langevin model that describes the evolution of the roughness of two interfaces that move towards each other and are coupled by a diffusion field. This model aims at describing the closing of the gap between two…
Based on an extension of the fiber bundle model we investigate numerically the motion of the crack front through a weak plane separating a soft and an infinitely stiff block. We find that there are two regimes. At large scales the motion is…
The propagation of a 3D crack in an heterogeneous material is studied using a phase field model. It is shown that in the case of randomly distributed inclusions of soft material in a matrix, the nature of the distribution has little effect…
This article concerns the stability of a model for mass-spring systems with positive damping and negative stiness. It is well known that when the coefficients are frozen in time the system is unstable. Here we find conditions on the…
Robustness of linear systems with constant coefficients is considered. There exist methods and tools for analyzing the stability of systems with random or deterministic uncertainties. At the same time, there are no approaches for the…
This paper concerns piecewise-smooth maps on $\mathbb{R}^d$ that are continuous but not differentiable on switching manifolds (where the functional form of the map changes). The stability of fixed points on switching manifolds is…
This note adds some critical remarks on the discussion presented in the McDonald's paper ([1]) on stability of steady motion of the well known problem of a disk rolling on a rough horizontal plane.
We develop continuum field model for crack propagation in brittle amorphous solids. The model is represented by equations for elastic displacements combined with the order parameter equation which accounts for the dynamics of defects. This…
This work deals with stability of two-phase stratified air-water flows in horizontal circular pipes. For this purpose, we performed a linear stability analysis, which considers all possible three-dimensional infinitesimal disturbances and…
We investigated the propagation of turbulent fronts in pipe flow at high Reynolds numbers by direct numerical simulation. We used a technique combining a moving frame of reference and an artificial damping to isolate the fronts in short…
We study the front propagation in Reaction-Diffusion systems whose reaction dynamics exhibits an unstable fixed point and chaotic or noisy behaviour. We have examined the influence of chaos and noise on the front propagation speed and on…
Patterns on broken surfaces are well-known from everyday experience, but surprisingly, how and why they form are very much open questions. Well-defined facets are commonly observed1-4 along fracture surfaces which are created by slow…
We revisit here the stability of a deformable interface that separates a fully-developed turbulent gas flow from a thin layer of laminar liquid. Unlike previous work, the turbulent base state velocity profile proposed here requires only a…
A spherical blast wave with relativistic velocity can be described by a similarity solution, that is used for theoretical models of gamma-ray bursts. We consider the linear stability of such a relativistic blast wave propagating into a…