Related papers: Isostatic phase transition and instability in stif…
The linear stability of rapid granular flow on a slope under gravity against the longitudinal perturbation is analyzed using hydrodynamic equations. It is demonstrated that the steady flow uniform along the flow direction becomes unstable…
This paper introduces a model for the mechanical response of anisotropic soft materials undergoing large inelastic deformations. The composite is constituted by a soft isotropic matrix reinforced with stiff fibres, that can evolve…
Fluidisation is the process by which the weight of a bed of particles is supported by a gas flow passing through it from below. When fluidised materials flow down an incline, the dynamics of the motion differ from their non-fluidised…
We analyse the flow curves of a two-dimensional assembly of granular particles which are interacting via frictional contact forces. For packing fractions slightly below jamming, the fluid undergoes a large scale instability, implying a…
Intermolecular forces are known to precipitate adhesion events between solid bodies. Inspired by a macro-scale experiment showing the hysteretic adhesion of a piece of flexible tape over a plastic substrate, we develop here a model of…
Thermodynamic equations for a solid and a solid continuum under stress are derived on the basis of a multicomponent mean field Markov process for thermofluctuation kinetics of microcracks. The resulting continuum is viscous elastoplastic…
The shear strength of cohesionless granular materials is generally attributed to the compactness or anisotropy of their microstructure. An open issue is how such compact or anisotropic microstructures, and thus the shear strength, depend on…
Dense granular flows are often unstable and form inhomogeneous structures. Although significant advances have been recently made in understanding simple flows, instabilities of such flows are often not understood. We present experimental…
A dense suspension of the cornstarch flowing on a very inclined wall finally forms some ridge-like patterns of the free surface. The onset of pattern formation is the primary target to elucidate the mechanism. In this work, based on the…
We show that grains streaming through a fluid are generically unstable if their velocity, projected along some direction, matches the phase velocity of a fluid wave (linear oscillation). This can occur whenever grains stream faster than any…
A systematic investigation is presented of grain boundaries and grain boundary networks in two dimensional flexible membranes with crystalline order. An isolated grain boundary undergoes a buckling transition at a critical value of the…
A significant amount of attention was dedicated in recent years to the phenomenon of jamming of athermal amorphous solids by increasing the volume fraction of the microscopic constituents. At a critical value of the volume fraction,…
We study the onset of delamination blisters in a growing elastic sheet adhered to a flat stiff substrate. When the ends of the sheet are kept fixed, its growth arouses residual stresses that lead to delamination. This instability can be…
Two granular gases separated by an adiabatic piston and initially in the same macroscopic state are considered. It is found that a phase transition with an spontaneous symmetry breaking occurs. When the mass of the piston is increased…
Power grids sustain modern society by supplying electricity and thus their stability is a crucial factor for our civilization. The dynamic stability of a power grid is usually quantified by the probability of its nodes' recovery to phase…
By performing extensive simulations with unprecedentedly large system sizes, we unveil how rigidity influences the fracture of disordered materials. We observe the largest damage in networks with connectivity close to the isostatic point…
Asymmetric nuclear matter at sub-saturation densities is shown to present only one type of instabilities. The associated order parameter is dominated by the isoscalar density and so the transition is of liquid-gas type. The instability goes…
Bistability is a major mechanism for cellular decision making and usually results from positive feedback in biochemical control systems. Here we show theoretically that bistability between unbound and bound states of adhesion clusters…
One long-lasting puzzle in amorphous solids is shear localization, where local plastic deformation involves cooperative particle rearrangements in small regions of a few inter-particle distances, self-organizing into shear bands and…
Repeated loading of a solid leads to microstructural damage that ultimately results in catastrophic material failure. While posing a major threat to the stability of virtually all materials, the microscopic origins of fatigue, especially…