Related papers: Shot noise in carbon nanotube based Fabry-Perot in…
We have measured shot noise in single walled carbon nanotubes (SWNT) with good contacts at 4.2 K at low frequencies ($f=600 - 850$ MHz). We find a strong modulation of shot noise over the Fabry-Perot pattern; in terms of differential Fano…
We study the low frequency current correlations of an individual single-walled carbon nanotube at liquid He temperature. We have distinguished two physical regimes -- zero dimensional quantum dot and one dimensional quantum wire -- in terms…
We have investigated shot noise in multiterminal, diffusive multiwalled carbon nanotubes (MWNTs) at 4.2 K over the frequency f = 600 - 850 MHz. Quantitative comparison of our data to semiclassical theory, based on non-equilibrium…
We study shot noise in the current of quantum dots whose low-energy behaviour corresponds to an SU(N) Kondo model, focusing on the case N=4 relevant to carbon nanotube dots. For general N, two-particle Fermi liquid interactions have two…
Low-temperature measurements of asymmetric carbon nanotube (CNT) quantum dots are reported. The CNTs are end-contacted with one ferromagnetic and one normal-metal electrode. The measurements show a spin-dependent rectification of the…
We have constructed a noise measurement setup for high impedance carbon nanotube samples. Our setup, working in the frequency range of 600 - 900 MHz, takes advantage of the fact that the shot noise power is reasonably large for high…
We measure the shot noise of a quantum point-contact using a capacitively coupled InAs double quantum dot as an on-chip sensor. Our measurement signals are the (bidirectional) interdot electronic tunneling rates which are determined by…
We have investigated shot noise in a 6-nm-diameter, semiconducting multiwalled carbon nanotube FET at 4.2 K over the frequency range 600 - 950 MHz. We find a transconductance of 3 - 3.5 $\mu$S for optimal positive and negative source-drain…
We study the zero frequency noise in an interacting quantum wire connected to leads, in the presence of an impurity. In the absence of quasiparticle decoherence the zero-frequency noise is that of a non-interacting wire. However, if the…
An on-chip detection scheme for high frequency signals is used to detect noise generated by a quantum dot formed in a single wall carbon nanotube. The noise detection is based on photon assisted tunneling in a…
We have analyzed the shot noise of electron emission under strong applied electric fields within the Landauer-Buttiker scheme. In contrast to the previous studies of vacuum-tube emitters, we show that in new generation electron emitters,…
We have performed noise measurements on suspended ropes of single wall carbon nanotubes (SWNT) between 1 and 300 K for different values of dc current through the ropes. We find that the shot noise is suppressed by more than a factor 100…
Using nonequilibrium Green functions and several complementary many-body approximations we calculate shot noise and spin dependent conductance in carbon nanotube semiconducting quantum dot in spin-orbital Kondo regime. We point out on the…
We present a novel method for the evaluation of shot noise in quasi one-dimensional field-effect transistors, such as those based on carbon nanotubes and silicon nanowires. The method is derived by using a statistical approach within the…
We analyze the shot noise in a voltage biased superconducting quantum point-contact. Results are presented for the single channel case with arbitrary transmission. In the limit of very low transmission it is found that the effective charge,…
We report on direct measurements of the electronic shot noise of a quantum point contact at frequencies nu in the range 4-8 GHz. The very small energy scale used ensures energy independent transmissions of the few transmitted electronic…
A fractional quasiparticle charge is a manifestation of strong interactions in the fractional quantum Hall effect. Nevertheless, shot noise of quasiparticles is well described by a formula, derived for noninteracting charges. We explain the…
We formulate a theory for shot noise in quantum nanoelectromechanical systems. As a specific example, the theory is applied to a quantum shuttle, and the zero-frequency noise, measured by the Fano factor F, is computed. F reaches very low…
The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…
Coupling carbon nanotube devices to microwave circuits offers a significant increase in bandwidth and signal-to-noise ratio. These facilitate fast non-invasive readouts important for quantum information processing, shot noise and…